Advertisement
1. Depress Advance
2. Depress and Hold Confirm
for 2 seconds until
Enter the desired amount of hours by depressing Advance to make the selection.
3. Depress Confirm
Enter the desired amount of minutes by depressing Advance to make the selection.
4. Depress Confirm
Enter the desired amount of seconds by depressing Advance to make the selection.
5. Depress Confirm
Depress Advance to select pulse duration (1-60 seconds). If pulse is not needed skip to step 6.
6. Depress Confirm
Enter the desired trigger option (OFF, ON, CNG) by depressing Advance to make the selection.
Removal of trigger will start time cycle.
OFF option starts timing cycle when trigger is removed.
ON option starts timing cycle when trigger is applied.
CNG option starts timing cycle when trigger is removed or applied.
7. Depress Confirm
Enter the desired relay option (OFF, ON, PLS) by depressing Advance to make the selection.
OFF option - relay turns off at the end of timing cycle.
ON option - relay energizes at the end of timing cycle.
Pulse option - relay energizes momentarily (1 to 60 sec).
Depress Confirm to accept .
- 4 -
Trigger Mode Programming:
00:00:00
will appear in display.
Change ?
00:00:00
will appear in display.
SetDelay
00:00:00
will appear in display.
SetDelay
00:00:00
will appear in display.
SetDelay
pulse = 1
will appear in display.
Set PLS
TRIG_OFF
will appear in display.
TRG_EDGE
RLY = ON
will appear in display.
Event
Tempo2 Installation Guide
Advertisement
