Advertisement
Parts List
2 - Return Handrails
■
2 - Mounting Blocks Rails
■
2 - Mounting Blocks
■
1 - Hardware Safety Pack
■
16 -
-10 x 3/4" Philips
¼
self-tapping screws
Tools Needed: Rubber Mallet,
cordless drill with Phillips bit.
Step #1
#1: Remove the Swing-up Ladder
assembly by flexing the oval
openings outward from the tabs on
the Platform.
#2: Remove the
two ¼-20 x 3 1/2"
bolts and ¼-20
hex nuts from the
pool ledge. Then
remove A-Frame
Ladder from pool
and lay it on its side.
Above Ground A-Frame Pool
Ladder Conversion Kit
Assembly and Installation Manual
:
#3: Using a cordless drill, remove
the four
#10 x 3/4" self-tapping
screws
that connect the Handrails
together
#4: Slide the remaining ladder
assembly out of the two holes
nearest the tabs of the platform and
set aside.
Part no. 400201
Step #2
#1: With the ladder still on its
side, slide the Return Handrails up
through the bottom of the Platform.
#2: Using two
#10 x 3/4" self-
tapping screws,
connect the Hand-
rail to the Return Handrail by using
one screw on the outside and one
screw on the inside. Repeat for the
remaining handrail.
Advertisement
Table of Contents
Related Manuals for Ocean Blue 400201
Summary of Contents for Ocean Blue 400201
- Page 1 Part no. 400201 Above Ground A-Frame Pool Ladder Conversion Kit Assembly and Installation Manual Parts List 2 - Return Handrails ■ 2 - Mounting Blocks Rails ■ 2 - Mounting Blocks ■ 1 - Hardware Safety Pack ■ 16 - -10 x 3/4”...
- Page 2 PRODUCTS WARRANTY PART TO DEALER etc.) showing date purchased, your name, address, and daytime phone Ocean Blue Water Products warrants The defective part should be number. You will be notified of cost to their swimming pool ladders to be free returned, postpaid, to: replace part.
Need help?
Do you have a question about the 400201 and is the answer not in the manual?
Questions and answers