Page 2
Congratulations ! You are the happy new owner of a MASH which embodies a new spirit, a new trend : a motorcycle with a look and a philosophy «Vintage», synonymous of freedom. Please read this manual thoroughly before using your MASH.
Page 3
Important Cautions About running-in of a motorcycle The first 1000 km operation is very important in the entire service life of a motorcycle. A correct running-in can guarantee both the longest service life and the best performance of the vehicle. Running-in can polish machined surfaces and form smooth engagement.
Observing the following recommendations will ensure the reliability of your motorcycle and prolong its life. The staff of MASH authorized dealers (list available by consulting the website www.mash-motors.fr) have the skills and technical qualifications required to carry out maintenance and provide quality service.
I - Main Technical Data Mash City 2.0 50cc Euro 5 Engine Type 4T single cylinder, air cooled Engine Capacity 50 cc Compression Ratio 10.5:1 Power max 2.8 hp at 8000 rpm (2,1kW) Ignition Transmission Automatic Gearbox Belt Spark plug...
Page 6
This scooter is equipped with a catalytic converter. The catalytic converter contains precious metals which act as catalysts. They promote the chemical reactions that convert the exhaust gases without being affected by these reactions. The catalytic converter acts on HC, CO and NO gases. The catalytic converter must operate at high temperature for the chemical reactions to occur.
II - User Instruction Preparation before use • Read the user manual carefully This user’s manual describes the standard and safety method as well as basic • Maintain and check the vehicle before using it maintenance. Read it carefully. • It is necessary to have the driving license corresponding to your vehicle and that The images and illustrations in this manual may differ from those of your vehicle, if it is insured...
Fuel level indicator lights up when the fuel level is low Front 5. Total odometer wheel 6. Engine light Rear If this indicator light comes on at the meter, it is necessary to go to an authorized wheel Mash dealer to make a diagnosis. Right side Kickstand Back to summary...
IV - Ignition switch. 1. Contactor Position ON Main switch used to start or stop the engine. When the switch is in this position, the front light, the front position light, the instrument cluster lighting and the rear light are on. Position Fonction Position OFF...
V - Control system Right handlebar control system Left handlebar control system Electric starter button Press this button to start the engine. Dimmer switch Press the button, using the switch allows Engine shutdown switch you to choose the distance of the headlights : It is used to manually stop the motorcycle in an high or low.
Make sure there is fuel in the tank. Caution To start the engine • If you hear an abnormal noise while riding, contact a MASH dealer for Start the engine by simultaneously pressing the engine start button (right stalk) inspection and have the necessary action taken.
Page 12
Box compartment Mirror Use the switch lock to unlock the saddle Before driving, adjust the angle of your mirror. to open the luggage compartment. Warning To lock the saddle, lower it until it clicks. Do not put anything on the back seat so as not to block your view in the Make sure the saddle is securely locked rearview mirror.
VII - Controls and setting Inspection before driving Before setting off, remember to check the following points. Never underestimate the importance of inspection. Element Check to be carried out Handlebar Ensure that management is: - soft - free - no hard point in rotation Lighting Operate all lights (headlight, taillight, front and rear brake light, instrument cluster lighting, turn signals)
Please note that the service interval is 3000 km. Do not forget to certify them in * Braking, front/rear brake pads, brake linings the maintenance sheets of the warranty book provided by your MASH dealer. * Brake fluid To be replaced every 2 years...
Page 15
Warning • Always check the travel of the front and rear brakes. • If an adjustment is necessary, it is recommended that you contact an authorized Mash repairer to adjust your combined braking. Back to summary...
Page 16
Tire pressure Air filter cleaning A clogged air filter will reduce engine power and increase fuel consumption. To The correct tire pressure is essential for the safety clean the air filter: and driving of the scooter. Tire pressure should be ●...
Page 17
Storage and cleaning Prolonged non-use of the scooter during winter or another season requires specific operations requiring suitable materials, equipment and techniques. Scooter If the scooter will not be used for an extended period of time, perform the following operations before storing it: Wash the scooter and stabilize it with its side stand on hard, level ground.
Page 18
2. Remove the spark plug; press the starter to let the engine run for a few moments Cleaning : before reinstalling the spark plug. Cleaners that are too acidic or aggressive are not recommended for washing the 3. Replace the battery. Note: Do not forget to connect the positive pole before the Scooter.
Page 20
Copyright in this manual and its ultimate interpretation is ours. Under no circumstances may this document or any part of it be reproduced or cited without our prior written permission. All information, descriptions, illustrations and specifications contained herein reflect the state of our knowledge at the time of publication. However, we reserve the right to modify this manual at any time in the event of improvements or other changes.
Page 21
Find your reseller JOIN US ON SOCIAL NETWORKS: @MASH_MOTORCYCLES @MASHMOTORCYCLES @MASH MOTORS FRANCE Mash préconise...
Need help?
Do you have a question about the CITY 2.0 50cc and is the answer not in the manual?
Questions and answers