Rompa 14519 Manual

Page 1 of 11
Suspension system not included - see ROMPA Catalogue for details of Hanging Bracket
(13672), Safety Snaps (13799), Safety Rotational Device (13738), Height Adjuster (13626) and
Therapy Rope with Eye Splice (13627, 14535).
Use of Height Adjusters is advisable.
CONTENTS
1. Linear Glider
2. Carpet with Velcro to hold in place
3. Safety Snaps x 2
4. Set of Pull Handles
5. Maintenance Checklist
NOTE: All hanging equipment requires a minimum ceiling height of 8 feet/2.5 metres and
should be positioned a clear distance of 6 feet/1.8 metres from any adjacent walls and other
obstacles.
Maximum weight supported: 250 lbs/113 kg
ASSEMBLY INSTRUCTIONS
1. Using the Safety Snaps provided, suspend the Linear Glider from the eye bolt of the Height
Adjuster.
2. It is better to use 2 Suspension points, but if only one is being used a Safety Rotational
Device must be used to prevent damage to the Glider.
3. Suspension from 2 Points:
Suspension Systems must be between 3.5 feet (105 cm) and
4.5 feet (135 cm) apart distance A.
Suspension from 4 Points
(requires 2 additional Safety Snaps - See above):
One set of Suspension Systems should be between 3.5 feet
(105 cm) and 4.5 feet (135 cm) apart distance A.
The other set should be in a parallel position 1 - 2 feet (30 - 60 cm)
away distance B.
MAINTENANCE CHECKLIST
All parts of the Linear Glider and its Suspension System should be checked
on a monthly basis and a record kept on the Maintenance Sheet provided.
Worn parts should be replaced or repaired immediately.
On the Linear Glider check for:
• wear on safety Snaps
• loose or missing splice locks * on ropes
* (metal lined loops at each end of ropes)
• wear of ropes at top where they rub against Safety Snaps and at
SOUTHPAW LINEAR GLIDER 14519
Copyright ROMPA® Ltd
SOUTHPAW LINEAR GLIDER 14519, KH 8.12