WB Manufacturing EPIC EPC-FX Assembly Instructions

Step 1:
• Place EPIC frame leg with plate facing down on a flat surface.
Step 2:
• Align holes in the end plate of the cross bar with the frame.
Make sure the tabs on the cross bar are facing down.
• Connect cross bar to the frame using 1/4"-20 x 50mm joint
connector bolts and 1/4"-20 joint connector nuts.
• Use a screw gun and a 4mm hex bit to tighten the joint
connector bolts to the nut. We suggest using a 4mm hex
wrench to hold the nut in place while tightening the bolt.
• Repeat for other frame leg.
Step 3:
• Place the EPIC top face down on a protected flat surface so
threaded inserts (marked in green) and pre-drilled pilot holes
(marked in yellow) are facing up.
Step 4:
• Place frame leg/cross bar on the top and align with threaded
inserts & pre-drilled pilot holes.
• Using a screw gun and a 4mm hex bit, secure both frame
legs to top with 1/4"-20 x 15mm joint connector bolts. Use
eight bolts for each frame leg.
Step 5:
• Using a screw gun and a # S2 square bit, secure cross bar
to top with #10 x 3/4" square pan screws. Use one screw per
tab with a total of six screws being used (3 per side).
Step 6:
• Before placing caster in the bottom of the frame leg, lock the
caster by pushing down on the brake lever.
• Twist the stem of the caster into the hole on the bottom of
the leg frame.
• Use 1 1/8" socket wrench to tighten 3/4" nut on stem of caster.
• Repeat for remaining casters.
NOTE: Casters are not to be used as a leveling device.
Loctite on casters will cause some resistance while
tightening, please make sure that casters are tightened all
the way to prevent possible damage to the stem of the caster.
Step 7:
• With someone's help, turn table upright.
wibenchmfg.com
Specifications are subject to change. Product
images are for illustrative purposes only and may
differ from the actual product.
Assembly Instructions
Laminate/Phenolic/Stainless Steel
Before you begin, please make sure all parts and proper
quantities are included. (See Part Identifier Key) Any parts
damaged during shipment must be reported within 24 hours of
receipt. To report information regarding damages or if you have
any questions, please call 800.242.2303.
Step 1
EPIC frame leg
Step 6
Step 3
Step 7
507 E. Grant St. Thorp, WI 54771 • P - 800.242.2303
EPIC Tables
& 1 Pc Hardwood Tops
To o l s R e q u i r e d
• Screw gun
• # S2 square bit
• 4mm hex bit
• 4mm hex wrench
• 1 1/8" socket wrench
Step 2
Joint connector bolt
Joint connector nut
Cross bar
Tab
Step 5
V121721 Version subject to change
Step 4
1