(Artcile Number: Receiver01) on the backside of the panel. It needs to be used in conjunction with the Radiance control system - Smart 1.0/ Smart 1.0Pro or Smartplug (NOT included in the box) - in order to meet the Ecodesign legislation of the EU/EC Directive 2009/125/EC.
Radiance dealer. Do NOT attempt to repair the heater by yourself, this will void your warranty. If the heater has been dropped do NOT operate it and contact your Radiance dealer to make sure it is free of any damages.
Please note that the heater may discolour with use. This is due to airborne pollution and is not a fault. If you wish to add a picture print to your heater please contact a Radiance dealer. Do not cover your heater with a picture foil and do not paint or print the heater yourself. This might cause damage to the heating element and will void your warranty.
Page 5
Receiver01 if they are in the same room. 5.3 Extra Safety Protection: The heater is equipped with the Radiance “Extra Safety Protection” function, which will automatically turn off the heater if it lost the signal from the Smart controller for more than one hour. And it will...
Please make sure the ceiling is safe to mount. We highly recommend to have the panel installed by Radiance. The SC series is a hot temperature infrared heater. It has a surface temperature of special attention and mount them out of reach.
Page 7
The mounting kit included in this box contains: Part A: 2x mounting handles Part B: 2x mounting handles Part C: 8x screws Part D: 8x wing nuts Part E: 4x wall/ceiling anchors Step 1: Slide the mounting handles (part A) into the rail on the back of the heater from the opposite side of the cables.
The warranty covers the repair or replacement of the heater only and Radiance shall not be liable for any other occurring costs such as installation cost or any other consequential losses however incurred. Please note that tampering with or opening the heater in any way will void your warranty.
Page 9
Information requirement for the electric local space heaters Models: SC-Plus + Smart1.0/Smart1.0Pro/Smartplug Item Symbol Value Unit Item Unit Heat output Type of heat input, for electric storage local space heaters only(Select one) Nominal heat output Pnom 1.8-2.4 manual heat charge control, with...
Page 10
Serial number of your Radiance infrared heater is : The Heating Company Ltd 117 Wairau Rd, Wairau Valley Auckland 0627, New Zealand info@theheatingcompany.co.nz www.theheatingcompany.co.nz...
Need help?
Do you have a question about the SC-Plus and is the answer not in the manual?
Questions and answers