Air Conditioner Controls; Remote Control - GE AGL12AD Owner's Manual And Installation Instructions

About the controls on the air conditioner—models with touch pads.
Features and appearance will vary.
Timer on
Cool on
Fan on
Energy
Saver on
FAN
Controls
ON/OFF Pad
Turns air conditioner on and off.
Display
Shows the set temperature or time remaining
on timer.
MODE
Use to set the air conditioner to COOL or
FAN mode.
Increase
Use to set temperature when in COOL mode.
FAN Pad
Use to set the fan speed to LOW (F1), MED (F2)
or HIGH (F3).
ENERGY SAVER
Controls the fan.
ON—The fan and compressor cycle on and
off. This results in wider variations of room
temperature and humidity. Normally used
when the room is unoccupied. NOTE: The fan
will continue to run for a short time after the
compressor cycles off.
OFF—The fan runs all the time, while the
compressor cycles on and off.
This feature must be set at OFF in order to
use the fan settings (on the mode control).

Remote Control

s
To ensure proper operation, aim the remote
control at the signal receiver on the air
conditioner.
s
The remote control signal has a range of
up to 21 feet.
4
Energy
Saver on
Timer
on

Air Conditioner Controls

v w
/Decrease Pads
(on some models)
Fan on
Cool on
NOTE: On some models, the ENERGY SAVER feature
cannot be set on the air conditioner. It must be set using
the remote control.
CIRCULAIRE
(on some models)
For continuous side-to-side air circulation
(cool settings only), set the Circulaire switch
to ON.
For fixed side-to-side air direction, turn ON
until the desired air direction is obtained,
then turn it OFF.
TIMER Pad
ON—When the air conditioner is off, it can be
set to automatically come on in 1 to 12 hours
or 1 to 24 hours (depending on model) at its
previous setting. Each touch of the TIMER pad
or the INCREASE v / DECREASE w pads
(depending on model) will set the timer
in hours.
OFF—When the air conditioner is on, it can be
set to automatically turn off in 1 to 12 hours or
1 to 24 hours (depending on model). Each
touch of the TIMER pad or the INCREASE v /
DECREASE w pads (depending on model) will
set the timer in hours.
To cancel the timer, press the TIMER pad until
the display time disappears.
Remote Control Signal Receiver
s
Make sure nothing is between the air conditioner
and the remote control that could block the
signal.
s
Make sure batteries are fresh and installed
correctly as indicated on the remote control.
Remote Control