HAMMON MANUFACTURING ECLIPSE Series Assembly Instructions

ECLIPSE - SERIES
ASSEMBLY INSTRUCTIONS FOR POINT LATCHING
SYSTEM ON SINGLE DOOR ECLIPSE ENCLOSURES
THREADED BARREL
ON L HANDLE
SEE STEP A
THREADEDSTUD
ON INSIDE OF DOOR
SEE STEP C
PART # QTY. DESCRIPTION
1 1 L HANDLE KEY LOCKABLE
2 1 GASKET
3 2 CAM SPACER
4 2 TOP AND BOTTOM ROLLER
CAM
5 2 NYLON WASHER
6 2 LOCK NUT
7 3 C RETAINING CLIP
8 1 LOCK ROD
9 1 HANDLE HEX NUT (27mm)
10 1 HANDLE HEX BOLT (7/16)
11 1 CENTER ROLLER CAM
12 1 HANDLE HEX NUT (17mm)
TOOL BOX
7/16", 27mm, 17mm,
Pliers
10mm Socket Wrench
SHOWN WITH 3 PT LATCHING
SYSTEM ON RIGHT SIDE OF DOOR
1
2
10
11
12
INSERT SHAFT OF L HANDLE (PART 1) WITH GASKET (PART 2)
THROUGH CENTER HOLE IN DOOR. HANDLE RUNS PARALLEL TO THE
SIDE OF THE DOOR IN CLOSED POSITION. INSERT THE HANDLE BOLT
(PART 10) THEN HANDLE NUT (PART 9) ONTO THREADED BARREL OF
HANDLE AND TIGHTEN BOTH.
MOUNT CENTER ROLLER CAM (PART 11) ONTO THE SHAFT OF THE
HANDLE AS SHOWN AND FASTEN USING THE HEX HD SCREW (PART
12). KEEP ROLLER CAM FACING OUT 90 DEGREES TO L HANDLE IN
SLIP CAM SPACER (PART 3) ON THREADED POSTS ON THE TOP AND
BOTTOM OF DOOR. SLIP THE ROLLER CAM (PART 4) ONTO THE
SPACER AND TIGHTREN USING A LOCK NUT AND NYLON WASHER
MOUNT THE LOCK ROD (PART 8) TO ALL THREE ROLLER CAMS BY
SLIPING THE ROD OVER EACH PIN ON EACH CAM AND THEN SECURE
IN PLACE WITH THE C RETAINING CLIP (PART 7). ALL THREE ROLLER
CAMS SHOULD LOOK THE SAME IN CLOSED POSITION AS ABOVE.
UNLOCK L HANDLE AND TURN CLOCKWISE AS SHOWN TO THE OPEN
POSITION. CLOSE THE DOOR AND TURN THE HANDLE BACK
COUNTER CLOCKWISE TO CLOSE. LOCK THE DOOR USING THE KEY
PROVIDED TO SECURE CONTENTS IN THE ENCLOSURE.
PAGE 1 OF 2
ECLIPSE SINGLE DOOR
8
9
ASSEMBLY INSTRUCTIONS
A)
B)
CLOSED POSITION.
C)
(PARTS 5 & 6).
D)
E)
HAMMOND
MANUFACTURING
ENCLOSURES
BUL10248
REV. B
3
4
5
6
7
TM