Halco sollos ColorSplash SCSBTR Installation Instructions

A Halco Lighting Technologies company
www.solloslighting.com
Important: T his d evice i s d esigned f or u se w ith 1 2V low v oltage l andscape p ower s ystems.
WARNINGS:
This d evice m ust b e i nstalled i n a ccordance w ith t he N ational E lectric C ode a nd l ocal c ode s pecifications.
Failure t o f ollow t hese c odes a nd i nstallation i nstructions w ill v oid t he w arranty a nd m ay r esult i n
serious i njury a nd/or d amage t o t he d evice. W hen u sing t his device with multiple l andscape lighting
fixtures, do n ot e xceed t otal w attage l oad a s s pecified b y t he t ransformer r ating. T his p roduct i s d esigned
for a bove g round i nstallation o nly. K eep t hese i nstallation i nstructions f or f uture u se.
IMPORTANT S AFETY W ARNINGS:
To reduce the risk of personal shock and injury, turn off the system power before installing the
repeater. Install t he r epeater n o l ess t han t en f eet f rom p ools, s pas, o r f ountains t o
minimize risk of electric shock. Always u se U L l isted w ire a nd w ire c onnectors f or c onnections.
MOUNTING THE REPEATER:
1) Locate the Repeater in the desired location.
NOTE: for best connectivity between the repeater and the installed Sollos® ColorSplash® lamps and
fixtures, it is recommended to locate the repeater in an area that is the most central location to the
installed Sollos® ColorSplash® products.
2) Install the repeater antenna by screwing it into the antenna plug located on the top of the repeater.
3) Use the supplied double-sided tape or screw hardware to mount the repeater.
4) Mount the repeater a minimum of 4" off of the ground.
5) The Repeater power cable can be routed straight out the back or out the bottom of the unit. For
routing out the bottom, press the power cable into the slot on the back of the unit.
Sollos L andscape L ighting • 2 940 P acific D rive • N orcross, G A 3 0071 • 8 88-­‐976-­‐5567 • w ww.solloslighting.com
Installation I nstructions
SCSBTR
Blue Tooth Repeater