Advertisement
MOUNTING INSTRUCTION MUDROCKER REAR
Silicon velcro straps for
fitting mudguards
Frame protection foil
1.Insert the rubberized wedge into the mudguard.
1.1. Adjust the space of the mudguard to the tyre. (2 positions possible)
1.
PARTS
Rubberised
wedge
EXTENDER
EXTENSION
or
2.
¬
11670
We strongly recommend to use the frame protection film.
1.2. Affix the protective film on the bicycle frame.
(Thoroughly clean the frame before affixing)
2. Thread the velcro strap with the rubberized side to the frame.
Always retighten the straps before the ride!
EXTENSION
EXTENDER
MUDROCKER
Riding in rough terrain, short contacts of the mudguard
GERMANY
ATTENTION!
End position strap
3. Optional
EXTENDER
ATTENTION!
Clamp the extender in the mudguard
and cut it so that it fits between
the seating stays.
Avoid in general the contact
to the seating stays.
and the tyre may occur.
MOUNTAIN
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for sks Mountain MUDROCKER REAR
Summary of Contents for sks Mountain MUDROCKER REAR
- Page 1 MOUNTING INSTRUCTION MUDROCKER REAR ¬ 11670 MOUNTAIN ATTENTION! PARTS We strongly recommend to use the frame protection film. Silicon velcro straps for Rubberised fitting mudguards wedge 1.2. Affix the protective film on the bicycle frame. (Thoroughly clean the frame before affixing) Frame protection foil EXTENDER 2.
- Page 2 MOUNTING INSTRUCTION MUDROCKER REAR EXTENSION ¬ 11670 MOUNTAIN 1. Using a 6 mm drillbit, drill a hole through the mudguard and extension at the marked location. 6 mm 2. Insert the plug from the outside through the two superimposed holes. 3.
Need help?
Do you have a question about the Mountain MUDROCKER REAR and is the answer not in the manual?
Questions and answers