Table of Contents
Advertisement
Quick Links
VR1000 3w Cool or Warm White User Manual
Specifications
Input Voltage: 240v AC 50-60Hz
Power Consumption: 75w
Dimensions: 1000 x 80 x 75mm
Weight: 5.1kg
LED's: 24 x 3w Cool or Warm White LED's
Beam Angle: 40deg
DMX Connections: 3 pin male / female flying leads with IP65 rated connectors
Mains Link: 4 pin male / female flying leads with IP65 rated connectors
Infra – Red Remote Control Sensor
Features
Infra Red Remote Control (Using optional VRIR remote Transmitter)
Stand Alone / Master Slave
DMX 512 Controllable (2 x Channel)
410Hz LED Driver Chips for Flicker Free Operation when using Video Equipment
IP65 Rated for Outdoor Use
Power and DMX Linkable
Low Power Consumption
Thermal Protection
Aluminium Housing with tempered Glass Front
Rubberised easy wrap cable
Optional Data & Power link leads are available in various lengths
Introduction
Thank you for choosing the VR1000 3w Cool or Warm White Baton.
Prior to use, please read all the instructions carefully paying particular attention
to the installation of this product.
By following the suggestions found in this user manual you can look forward to
long and reliable service of your new product.
Unpacking, Inspection and Installation
Please check that the following items are included in your packaging. If anything
is missing please contact your dealer.
VR1000 Unit • Power cord with 13A mains plug
Carefully remove all packaging materials from the box, ensuring that all foam
padding is discarded responsibly.
This unit can be mounted and operated at any angle; however we would
recommend using a suitable safety chain if the unit is to be installed above head
height. As little or no heat is generated by the unit it can safely be installed
behind marquee linings and drapes.
Advertisement
Table of Contents
Related Manuals for LED Technologies VR1000
Summary of Contents for LED Technologies VR1000
- Page 1 Optional Data & Power link leads are available in various lengths Introduction Thank you for choosing the VR1000 3w Cool or Warm White Baton. Prior to use, please read all the instructions carefully paying particular attention to the installation of this product.
- Page 2 Colour Changing Units, hence the difference in key selection. VRIR Instructions Point the VRIR controller at the IR lens on the front of the VR1000 Baton. 1. Press BLCK OUT to switch the units on or off. 2. Press the “A button to select the Pulse Mode. Note: Pressing A again will toggle between Pulse and Off.
- Page 3 3. Press the 0 button again, note that the sequence of LED’s will change; indicating that the second number in the 001 address has been entered. 4. Press the 1 button, note that all the LED’s on the unit light, will flash and then go out, indicating that the final number in the 001 address has been set and the unit is ready to accept a DMX signal from the controller.
Need help?
Do you have a question about the VR1000 and is the answer not in the manual?
Questions and answers