Sony D-NE800 Operating Instructions Manual page 32

Connecting a stereo system
Notes
• Before you play a CD, turn down the volume of
the connected device to avoid damaging the
connected speakers.
• Use the AC power adaptor for recording. If you
use the rechargeable batteries or dry batteries as a
power source, the batteries may become
completely depleted during recording.
• Adjust the volume properly on the connected
device so that the sound will not be distorted.
• This CD player uses the Serial Copy
Management System, which allows only first-
generation digital copies to be made.
• When recording or playing an ATRAC CD/MP3
CD using a connected device, use only the analog
connecting cord.
• If you change the connected device, make sure to
change the "AUDIO OUT" setting.
When the headphones or other
devices are connected to the i/LINE
OUT (OPTICAL) jack
When an optical digital connecting cord is
connected, the output is automatically
switched to an optical digital output.
When a remote control or a connecting cord
is connected, the current AUDIO OUT
setting ("HP" or "LINE") flashes for about 5
seconds.
If you connect another device to the i/LINE
OUT (OPTICAL) jack, first remove the
device and connect the headphones again,
then switch the AUDIO OUT setting to "HP."
When AUDIO OUT is set to "LINE"
You cannot adjust the volume of using VOL
+/– on the CD player or the remote control.
When using an optical digital
connecting cord
To record a CD on a MiniDisc, DAT, etc.,
make sure that the CD player is paused
before starting the recording procedures.
32
-GB
About the G-PROTECTION and
equalizer functions when using the
connecting cord or the optical digital
connecting cord
• To record high quality CD sound, set the
G-PROTECTION setting to "G-PRO 1" on
the menu.
• If the AUDIO OUT setting is set to
"LINE," the parametric equalizer function
does not work.