PI-1000 Series Battery Information
Question:
I just bought the Argox PI-1030, what should I notice on the battery charging?
Model Applies to:
PI-1000 Series
Answer:
Inserting or replacing battery
When you see the battery icon shows low. You need to change new battery or
charge it immediately. If there is no power, the back up battery can hold the data
about 15 minutes. Therefore, always upload your important data after work or
keep two AA batteries in case.
Caution
Do not mix old batteries and new batteries or standard (carbon-zinc) with
alkaline batteries. Remove batteries if product is not to be used with for a long time. Risk
of explosion if battery is replaced by an incorrect type. Dispose of used batteries
according to the instructions.
DO NOT RECHARGE DIFFERENT TYPES OF BATTERIES.
1. Press and slide two release latches at the same time to open the battery
cover.
Address: 7F, No.126, Lane 235, Baoqiao Rd., Xindian Dist., New Taipei City, Taiwan, R.O.C.
Phone: 886-2-8912-1121
FAX
: 886-2-8912-1124
立象科技股份有限公司
ARGOX INFORMATION CO., LTD.