Bosch CR5CBCC User Manual page 13

From
XC-DA/ECR3-Bp
Report
Issue 1.0
Topic CR5CBCC User Manual
Figure 4: Maximum angle between fascia and radar cone
Distance between sensor and fascia
The minimum distance between the sensor radome and the fascia or any other part of the
vehicle may not be smaller than 3 mm.
This is valid for fascia parts fulfilling the following requirements.
Figure 5: Minimum distance above sensor radome
The distance between the sensor radome and the fascia should be however as close as
possible to the minimum value in order to reduce the risk of multipath reflection and
consequently to prevent ghost targets.
Vertical tilt of fascia (CR5CB)
The vertical tilt angle between the sensor normal and the surface normal of the fascia shall be
in the range according to the following table.
Our Reference
Daniel Radics
Tel
+36 1 879-6276
CR5CBCC_User_manual.docx
Budapest
10 June 2021
Page 13 of 17