Table of Contents
Advertisement
Quick Links
7. Fault Handling
Fault
Inspection
1. Make sure the plug is properly connected
1. Power supply is not
to the socket.
properly installed
Air pump
2. Allow natural cooling of the motor and then
2. Overheated motor or
cannot be
restart.
overload leads to motor
switched on
3. If the problem still exits, please contact local
stop
normally
service agent or similar authorized personnel
for replacement.
1. Replace the hose or make it clear and
1. Check whether the hose
smooth. Check whether the hose is cracked
Slow or abnormal
is blocked or cracked
2. Reinstall the hose
2. Connection between the
inflation
3. If the problem still exits, please contact local
hose and the air pump or
service agent or similar authorized personnel
the air bag is not properly
for replacement.
installed
8. . Maintenance
and Storage
After using and before moving away, servicing, maintaining or
*
adjusting this product, disconnect the power supply directly.
Please allow full cooling and ensure proper storage when not in use.
*
Please use it indoors or in a covered area to prevent direct sunlight
*
or rain.
*
Please store it in a dry and well-ventilated place.
9. Suggestions
*
The warranty period of the product is 1 year. It is recommended to
use the original spare parts. Any failure to satisfy this requirement
will not be covered by the warranty. Contact the USA manufacturer
with any warranty concerns.
USA Manufacturer:
Neoprene Distributors International / Island Hopper
Products
Manufacturer's address:
11859 Lakeshore North.
Auburn, CA 95602
530-268-7300
www.watertrampolines.com
Manufacturer:
Dongguan Huatao Metal and Plastic Products Co., Ltd.
Manufacturer's address:
NO.2, Yanhe East Road, XiaBian Avenue, Chang'An Town,
Dongguan City , Guangdong Province, China
Solution
Operating Instructions for
Island Hopper Power Egg Pump 120V
3135568
Please read the operation instructions carefully before using this product.
Please operate in the correct way based on complete understanding.
HT-309 AC110-120V 60Hz 600W
Advertisement
Table of Contents
Summary of Contents for ISLAND HOPPER Power Egg HT-309
- Page 1 1. Replace the hose or make it clear and Island Hopper Power Egg Pump 120V 1. Check whether the hose smooth. Check whether the hose is cracked Slow or abnormal is blocked or cracked 2.
- Page 2 HT-309 AC110-120V 60Hz 600W HT-309 AC110-120V 60Hz 600W Inflation inlet Deflation outlet Plug Air nozzle Power switch button (Figure 1) Hose (Figure 2) Hose coupler Deflation operation 1. Product Introduction Remove the hose from the inflation inlet. Connect the end with flexible conduit adaptor of the hose with the air pump deflation outlet, and twist clockwise to tighten it, as Figure 3.
Need help?
Do you have a question about the Power Egg HT-309 and is the answer not in the manual?
Questions and answers