Subscribe to Our Youtube Channel
Related Manuals for Cavalli Audio Liquid Carbon
Summary of Contents for Cavalli Audio Liquid Carbon
- Page 1 Liquid Carbon ® Balanced Transportable Headphone Amplifier Cavalli audio ® Copyright © 2015-2016 Cavalli Audio, LLC All Rights Reserved...
- Page 2 Page 2 of 15 Copyright © 2015-2016 Cavalli Audio, LLC...
-
Page 3: Return Policy
Transportable Headphone Amplifier! Amplifier Break-In Your Liquid Carbon® amplifier has been tested before leaving the factory, but has very few hours on it. Most amplifiers need at least 150 hours of continuous use, playing music, to reach their full sound signatures. We recommend about the same for the Liquid Carbon®. - Page 4 The amp has two gain settings to help with the wide range of headphone impedances and sensitivities. The high gain is 3X and the low gain is 1X. The Liquid Carbon® circuit allows you to hot switch the gain using the front panel switch.
-
Page 5: Operation
Operation Your Liquid Carbon® amplifier operates over a wide variety of power conditions, 85-265VAC/50- 60Hz. 1) Insert the proper power cord. Be absolutely sure that your power cord has an approved safety ground connection from the amp to the outlet. - Page 6 CAUTION Please remember to turn down the volume (or power down completely) before plugging or unplugging any sources or headphones into or from your Liquid Carbon ® Doing so will protect your both your hearing, and your equipment (headphones, Liquid Carbon , etc.).
-
Page 7: Headphone Outputs
Headphone Outputs The Liquid Carbon® Balanced Transportable Headphone Amplifier is equipped with one 4 Pin XLR output, one 4 Pin RSA (Kobiconn) output, and one TRS (Phone). All three output jacks are on the front panel. 4 Pin XLR This jack supports headphones wired with a 4 Pin fully balanced connector. This jack is labeled above the round jack with the letters “bal”. - Page 8 Balanced vs Single Ended Outputs The Liquid Carbon® is a versatile balanced amplifier in that it can receive both Balanced and SE inputs, always working in balanced mode, and it offers both Balanced and SE outputs. When using the Carbon, however, it is important to remember that the Carbon is designed to perform its best using the balanced output.
- Page 9 This diagram shows the power button at left, gain button in center, and input selector button at right. There are two balanced outs, 4 Pin XLR and RSA. There is one SE out TRS jack. Copyright © 2015-2016 Cavalli Audio, LLC Page 9 of 15...
- Page 10 This diagram shows the power inlet at right. There is on set of 3 Pin XLR jacks for balanced input. There are 2 RCA jacks and one 3.5mm TRS jack for SE input. SE input is phase split to create a balanced signal to the amplifiers. Page 10 of 15 Copyright © 2015-2016 Cavalli Audio, LLC...
- Page 11 Ventilation The Liquid Carbon® dissipates about 8W of power. The Carbon is designed to run a little warm in a small enclosure, but it still needs good ventilation. Don’t enclose it in a space with no air flow or on top of equipment which gets hot.
-
Page 12: Standard Warranty Limitations
Warranty This Cavalli Audio product has a 1-Year warranty for parts and labor. Warranty does not include fully insured shipping costs to Cavalli Audio. Warranties are not transferable unless pre- authorized in writing by Cavalli Audio. If the repair is due to customer damage or negligence, repairs will be charged as parts and labor, which will be quoted before work is performed. -
Page 13: Limitation Of Liability
Limitation of Liability IN NO EVENT WILL CAVALLI AUDIO OR ITS SUPPLIERS BE LIABLE TO CUSTOMER FOR ANY CONSEQUENTIAL, SPECIAL, PUNITIVE, INCIDENTAL, OR INDIRECT DAMAGES OF ANY KIND ARISING OUT OF THE USE OF OR INABILITY TO USE THE PRODUCT, INCLUDING LOST PROFITS,... - Page 14 Page 14 of 15 Copyright © 2015-2016 Cavalli Audio, LLC...
- Page 15 ® Cavalli Audio – 3300 Mossy Grove Court – Cedar Park, TX 78613 Copyright © 2015-2016 Cavalli Audio, LLC Page 15 of 15...
Need help?
Do you have a question about the Liquid Carbon and is the answer not in the manual?
Questions and answers