Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Summary of Contents for SCA RC2
- Page 1 DYNAMIC GUIDELINE REVERSE CAMERA INSTRUCTION MANUAL PLU 570908...
-
Page 2: Product Overview
Product overview Thank you for purchasing the SCA-RC2 Dynamic guideline reversing camera. The Dynamic guidelines show the path of intended motion of the vehicle while reversing. This product is designed for easy DIY installation but does require some specific tools. - Page 3 Wiring Install Diagram Monitor/Display (Not included) 6 Metre RCA extension cable Camera Power connector Positive wire connects to reversing lamp The video signal is transferred from the camera to a monitor/display via an RCA cable that will need to be run through the boot, through the passenger compartment to the monitor/display wired loom, run under the dash.
-
Page 4: Wiring Diagram
Wiring Diagram Power Harness Reversing Camera Female Female Power connector (Red) (Yellow Video/Signal) Male Male Power RED wire connector (Yellow Video/Signal) 12V+Power (Black) connector Video adapter cable Positive wire RED wire connects to 12V+Power power wire connector on display Alternative monitor power supply (Optional) -
Page 5: Installation
Installation When mounting the camera, make sure that the camera does not cover any part of the license plate. Choose a position that does not impede the access/operation of the boot release or tailgate latch. 1. Connect the RED wire of the video adapter cable to the wire that supplies power to the reversing lamp (the wire that is energized only when the car is put into reverse). - Page 6 Installation 3. Connect one end of the supplied RCA cable to the RCA socket from the camera, then run the RCA cable to the front under side of the driver side dash board. This is where the monitor/display loom will be located. To do this you may need to remove the rear seat and or door scuff plates to run the wire along the side of the vehicle.
-
Page 7: Product Specifications
Testing the reversing camera action 1. Engage the park brake and turn the ignition key to the on position. DO NOT start the vehicle. 2. Select reverse gear with the gear shift. The monitor/display will trigger and turn on automatically when it is energized from the reverse light. -
Page 8: Warranty
WARRANTY This product is guaranteed against defects for a period of 12 months from date of purchase. This warranty is provided by SRGS Pty Ltd ABN: 23 113 230 050 (Supercheap Auto) of 6 Coulthards Avenue, Strathpine, Queensland 4500, Australia. Ph (07) 3482 7500. Supercheap Auto will offer a repair, replacement product or store credit if the product is assessed as being defective during the warranty period.