ESSE-CI TERES IP66 Assembly Instructions

Advertisement

// Avvertenze. La sicurezza dell'apparecchio è garantita solamente con l'uso appropriato delle presenti istruzioni che devono essere
lette e conservate. • Togliere tensione di rete prima della sostituzione delle lampade e comunque prima di ogni operazione di
manutenzione. • Non coprire l'apparecchio con panni o con quant'altro possa causare un eccessivo surriscaldamento. • La nostra
azienda declina ogni responsabilità per danni causati da uno scorretto utilizzo o dalla manomissione dell'apparecchio stesso. • Per la
sostituzione di componenti usurati rivolgersi a personale qualificato. • L'apparecchio non deve essere smaltito come rifiuto urbano. Deve
essere soggetto a raccolta separata per evitare danni all'ambiente nel rispetto della direttiva 2002/96 e delle leggi nazionali per lo
smaltimento del prodotto a fine vita. Il mancato rispetto di quanto sopra è sanzionato dalla Legge. • Si prega di informarsi in merito al
sistema locale di raccolta differenziata per i prodotti elettrici ed elettronici.
// Warning. The safety of the fixture is guaranteed only under the correct use of the present instructions, which have to be read and kept. •
Turn off the net voltage before the replacement of the lamp and however before any maintenance action. • Do not cover the fixture with
clothes or something else which could cause an excessive overheating. • Our company declines all responsability for damages causes by
an incorrect use or by the tampering of fixture itself. • For replacement of worn out components please address to the skilled staff. • The
fixture could not be disposed as urban waste. It must be subject o separate waste collection to avoid environmental damage in compliance
with directive 2002/96 and national laws for the disposal of product at the end of its working life. The non-compliance of the above
mentioned directive will be sanctioned by Law. • We ask you to kindly get information about local separate waste collection system for
electric and electronic products.
T E R E S I P 6 6
// Istruzioni per il montaggio // Assembly instructions
Esse-Ci Srl
Viale del Lavoro 25, 35010 Vigonza (PD) Italy
Tel. +39 049 8959511
info@esse-ci.it,
www.esse-ci.it
ISTRIP_02
A
+
5 years warranty
Direct Emission
UGR <22
IP 66
IK 06
-20°C +40°C
3000K
>108 / >120lm/W
CRI >80
Eye safety: RG0/RG1
Mac Adams 3
L80/B10 >50.000h
Attenzione: prima di procedere con ciascuna delle seguenti
operazioni, togliere la tensione di rete ed utilizzare i guanti in
dotazione.
Attention: before proceeding with each of the following
operations, switch off the power supply at the consumer unit.
Use the gloves supplied.
Attention: avant de procéder aux opérations suivantes,
éteignez la tension de ligne et utilisez les équipements de
protection individuelle (gants, lunettes, chaussures).

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the TERES IP66 and is the answer not in the manual?

Questions and answers

Summary of Contents for ESSE-CI TERES IP66

  • Page 1 // Warning. The safety of the fixture is guaranteed only under the correct use of the present instructions, which have to be read and kept. • Esse-Ci Srl Turn off the net voltage before the replacement of the lamp and however before any maintenance action. • Do not cover the fixture with Viale del Lavoro 25, 35010 Vigonza (PD) Italy clothes or something else which could cause an excessive overheating.
  • Page 2 verificare periodicamente il serraggio delle viti check periodically the proper tightening of the screws size 42mm 26mm 19mm small medium 70mm 30mm 30mm lose the screw before adjust the position, then fix it again allentare la vite prima di ruotare corpo, poi fissarla H05RN-F 3x1.0mm for cable/pipe Ø5-10mm 355°...
  • Page 3 Law. • We ask you to kindly get information about local Attention: before proceeding with each of the following T. +39 049 8959511 // info@esse-ci.it operations, switch off the power supply at the consumer unit.
  • Page 4 loosen the 2 screws allentare le 2 viti 355° Thin Thick While installing the front ring with the glass, please take care of the direction. The side with thicker gasket (glass surface with paint )is for inward, the smooth side with thinner gasket is for outward. So that to ensure the gasket could be worked effectively.

This manual is also suitable for:

Teres ip66 smallTeres ip66 medium14vt31l310m6614vt31l320m6614vt31l340m6614vt31l370m66 ... Show all

Table of Contents