Advertisement
Quick Links
INSTALLATION INSTRUCTION
High Voltage Led strip
BEFORE YOU START :
Please check local electrical codes before beginning
Use only proper glass glue seal
Make sure that glue has time to cure before final installation
Led Strip is cut at the gap only
For the correct installation, read the following instructions.
1: Where to cut?
2: Seal end cap with glass glue
3: Insert H pins into the metal wire
Advertisement
Summary of Contents for LEDLight 69857
- Page 1 INSTALLATION INSTRUCTION High Voltage Led strip BEFORE YOU START : Please check local electrical codes before beginning Use only proper glass glue seal Make sure that glue has time to cure before final installation Led Strip is cut at the gap only For the correct installation, read the following instructions.
- Page 2 4: How to connect power cord & middle connection? NOTE: Please apply glass glue at every connectors to make sure waterproof after checking Led Strip work properly. 5: How to fix Led Strips? ← Channel Three options for fixing Led Strip: Plastic Fix Clips; Plstic channel; Aluminum channel.
- Page 3 Bending Direction The minimum bending diameter is 12cm SAFETY PRECAUTIONS • To reduce the risk of fire, electric shock or injury, do not leave the light strip energized if its operation is not necessary. • This Led strip is IP67, it is not made to be submerged, so it is important to perform the installation in the best way with material that prevents the entry of corrosive agents.