Gram ECO-S Instructions Manual

DIFFERENTIAL PRESSURE CONTROL TYPE ECO-S (zone 22)
Program
line no. Function
L1 Hour counter
L2 Cycle counter
P1 Break time between
valve activation
P2 Valve opening time
P3 After-cleaning time or
cycles
P4 After-cleaning activa-
tion
P5 Measuring device
P6 Function for after-
cleaning
P7 Operation hours /
differential pressure
operation
P8 Activation of cleaning 0.90
P9 Stop of cleaning
P10 Activation of after-
cleaning
P11 Activation of relay 1
P12 Parameter for
dust build-up
P13 Value for dust build-
up
P16 Selection of function
for relay 1
P17 Function for relay 1
P18 Value for the function
in relay 1
P19 Break time between
valve activation valid
for after-cleaning
H0 0-calibration of dif-
ferential pressure
sensor
V. Aa. Gram A/S
Lysbjergvej 10 Hammelev
Tel.: +45 74 52 30 75 Fax: +45 74 53 01 64
info@vaagram.dk www.vaagram.com
INSTRUCTIONS FOR
VAa Gram
value
20
(5-30)
0.25
5
1
3
1
1
0.40
0.1
2.30
G115A/
G116A = 3.00
0
1.20
0
0
1
3
Tank must have
sufficient time to
be filled
1 - Fan must be turned off and may not rotate.
2 - Filter control must for min. 15 min. be connected to power before cali-
bration may take place.
3 - Press key E for 4-5 sec., until 0 does not flash anymore, press again
key E to confirm calibration.
DK-6500 Vojens
Optional values Explanations
0-65534 hours Hour counter function
0-65534 cycles Cycle counter function
1-999 sec. Value for hours and differential
pressure operation
0.03-9.99 sec.
1-999 sec. Length of after-cleaning
1-999 cycles
0=Deactivated After-cleaning control
1=Internal
2=External signal
0=Tenth Pa Differential pressure view in
1=mmH2O Display
2=mbar
3=KPa
4=mmHg
0=Time After-cleaning function
1=Cycles
0=Operation hours
1=Differential pres-
sure operation
0-9.99 KPa Differential pressure cleaning
active
0-9.99 KPa Differential pressure cleaning
stop
0-9.99 KPa Threshold value for start of after-
cleaning
0-9.99 KPa Alarm relay for filter change view
0=Deactivated Function for the delay of differen-
1=Activated tial pressure cleaning start, until
the value has been achieved the
0-9.99 KPa
first time.
0-1 Relay output function
0=Normal
1=Hysterese pres-
sure
2=Timing
0-9.99 KPa
1-999 sec.
1-999 sec. After-cleaning delay between
valve activation
1