Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Summary of Contents for Owon SLC601
- Page 1 SLC601 ZigBee Smart Relay Module Quick Start Guide...
- Page 2 Safety Handling WARNING: Failure to follow these safety notices could result in fire, electric shock, other injuries, or damage to the Smart Relay Module and other property. Read all the safety notices below before using the Smart Relay Module. • Avoid high humidity or extreme temperatures. • Avoid long exposure to direct sunlight or strong ultraviolet light.
- Page 3 Technical Specifications Wireless Connectivity ZigBee • 2.4GHz IEEE 802.15.4 ZigBee Profile • ZigBee HA1.2 • Operating frequency: 2.4GHz • Range outdoor/indoor: 100m / RF Characteristics • Internal PCB Antenna Physical Specifications Operating Voltage • 100~240 Vac 50/60 Hz Power consumption • < 0.7W • 5A Resistive Load: 1) 500W incandesent bulb or Max.
- Page 4 Welcome The SLC601 is a smart relay module that allows you to turn the power on and off remotely as well as set on/off schedules from the mobile app. This guide will provide you with an overview of the product and help you get through the initial setup.
- Page 5 Installation Please refer to the installation diagram below to install the smart relay module. Please make sure the main power in your facility is off before installing. Op�onal Physical switch Live Neutral Control light or hea�ng/ ven�la�on to On/Off Wiring diagram...
- Page 6 Get to know your device Reset button LED indicator Reset button Reset: Press and hold the reset button for ten seconds until the LED indicator flash for 3 times at third seconds and flash again for 3 times at tenth seconds. The indicator will keep flashing when the device is returned to default factory setting.
- Page 7 Configure Network 4.1 To get started, you will need: • A Zigbee Gateway. • A mobile phone with a mobile APP installed. 4.2 Adding to the gateway's network 1. Set your gateway to permit joining (see your gateway's manual). 2. Power on the smart relay module and make sure the LED indicator is flashing (If not, reset it to factory defaults).
Need help?
Do you have a question about the SLC601 and is the answer not in the manual?
Questions and answers