Advertisement
Barrel Buddie
™
BECOMING FAMILIAR WITH YOUR BARREL BUDDIE
CONTROLLER
The Controller has four jacks:
High Water Sensor
➊
Low Water Sensor
➋
Transformer
➌
Solenoid
➍
Each jack is different size and/or design,
so there is no confusion which cord plugs
into which jack.
➍
Model# 270669
Installation, Operation & Maintenance Guide
The Controller will perform the following
functions:
➊ Show a solid red LED when the unit
is powered on
➋ Open solenoid when low water sensor
is activated
➌ Close solenoid when high water sensor
is activated
➍ Flash blue LED and sound alarm if backup
high water sensor is activated
In the event of a power outage, the unit
will shut off. Pressing the on button will
activate the unit again.
On/Off Button
➌
➋
➊
2
www.aquaticlife.com
BECOMING FAMILIAR WITH YOUR BARREL BUDDIE
HIGH WATER SENSOR
The High Water Sensor is actually two sensors
in one. The bottom sensor detects the water
level and closes the solenoid.
There is a second back-up sensor closer to
the magnet attachment. If water should
continue to fill your container and reach the
top sensor, the Controller will flash a blue LED
and sound an audible alarm.
The strong magnet makes it easy to
position the sensor in most plastic and
rubber containers.
LOW WATER SENSOR
When the Low Water Sensor detects the
water fall below the sensor, the Controller
will open the solenoid and allow water to
fill the container.
The strong magnet makes it easy to
position the sensor in most plastic and
rubber containers.
Remove/reposition the sensor
using the easy grip ring.
Also functions as a cord router.
Top Sensor
Bottom Sensor
3
Advertisement
