Cairpol Cairsens Use Manual

Ambient air sensor

Advertisement

Quick Links

General Use Guide
— It is recommended to read the instructions before using the unit —
Cairsens
AMBIENT AIR SENSOR
April 2018
Warning
The information contained within Environnement SA document is for information purposes only
and is subject to change without notice.
Environnement SA cannot be considered liable for direct, indirect or collateral damages due to non
compliant use and/or inappropriate use of the equipment or information contained within this
document and our technical manuals.
Environnement SA makes no warranties expressed or implied within this documentation.
111 bd Robespierre, 78300 POISSY – TEL. 33(0)-1.39.22.38.00 – FAX 33(0)-1.39 65.38.08 – www.cairpol.com
P
A G E
(GUG)
— C A I R P O L
1
4
RECOMMENDS THAT YOU READ THE INSTRUCTIONS BEFORE STARTING THE UNIT
O N
1. GÉNÉRAL
The Cairsens is a device for measuring the quality of the air. It must be handled with care.
It is strongly advised to carefully read the instructions for use described in this manual.
2. ACCESORIES OF CAIRSENS USB (CAIRCLIP)
The following accessories are essential to the use of Cairsens daily:
7
1
2
6
4
3
1
5
7
Equipment optional:
Cairtub 3 sensor: Protective case for sensors with 3 USB batteries to a range of about 21 days.
Download tools, configuration, visualization and export data of Cairsens:
Cairsoft (V4.5.and up) : available on our website

3. COMMISSIONING AND OPERATION CAIRSENS

Power supply and charging:
The Power supply (or recharging) of the internal battery of Cairsens module is done by a charger and a USB-to-mini-USB type B cable supplied.
Necessary power supplied to recharge the internal battery:
Logo « batterie »
 Alternative AC: 110 V - 60 HZ / 220 V - 50 Hz. plug type EU.
 Continuous DC: 5 V / 1 A.
Battery specifications:
 450 mAh capacity
 Lithium Polymer (LIPO with included protection circuit).
(1)
1 Cairsens USB version
(2)
1 dongle USB, red connected to Cairsens
(3)
1 dongle USB, green.
8
(4)
1 set of 2 filters
(5)
1 charger AC110/220V toward USB 5V/1A.
(6)
1 USB Cable toward special mini USB type B.
(7)
1 adapter plug EU / US (option)
(8)
1 holster.
Filters of Cairsens gas {CH 2 O – CO - NO2 - NMVOCs} do not
*
contain the white material.
www.cairpol.com
or by clicking
here

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Cairsens and is the answer not in the manual?

Questions and answers

Summary of Contents for Cairpol Cairsens

  • Page 1 The Power supply (or recharging) of the internal battery of Cairsens module is done by a charger and a USB-to-mini-USB type B cable supplied. Environnement SA cannot be considered liable for direct, indirect or collateral damages due to non...
  • Page 2 • Either from the USB port of a computer (the Cairsens measure continues normally during this phase). Humidity and temperature readings: The battery of Cairsens is initially charged charged to 100% at the factory, however, a natural discharge can occur and be recognized upon delivery.
  • Page 3  The Cairsoft is available on our web site '' www.cairpol.com '' under '' Download '' then '' Software '' or by clicking on this link. It done a measure of the concentration of pollution in continue by the 3 left digits [1] and the 2 right Display example = 8060 ppb ...
  • Page 4 In these conditions, the electrochemical sensor of Cairsens will recondition in ambient air. This method requires much more time than the last. The name Cairpol, the Cairpol logo, the name of the products in its range and slogans and the technology developed by Cairpol are, unless otherwise ...

Table of Contents