Download Print this page

KoolScapes CSFK-5 User Manual page 2

Advertisement

OVERVIEW
• The solar pump is designed for outdoor fountain use, and is powered by a solar panel.
In order to make the pump work by solar energy, the solar panel needs to be placed in
the sunlight facing the sun.
• The performance of the pump depends on the sunlight intensity and the orientation of
the solar panel.
COMPONENTS
- solar panel
- pole 1
- pole 2
- panel support
- pump with plug
TECHNICAL DATA
Peak Power of Solar Panel
1.5W
Operation Voltage
8V DC
Maximum Water Lift Height
120cm (47.2")
Maximum Flow Rate
230L (61 gallons) / h
Cable Length
5m (16.4 ft)
ASSEMBLING
1. Unpack all components carefully.
2. Find a suitable spot and place bowls on the stand.
3. Loop the tube from the top pitcher through
the stand's small loops. See picture.
4. Place pump in the bottom bowl.
5. Connect the end of tube to the adapter on
the top of the pump.
6. Connect the pump's cable to the assembled
solar panel.
7. Fill bottom bowl with water, making sure the
pump is fully submersed.
8. Place solar panel in direct sunlight.
8. The pump is now ready to operate.
CLEANING AND MAINTENANCE
• If after some time the pump starts losing power or stops working, please clean up
sediment in the pump shell or filter cribs.
• The pump can be opened by pressing down at the bottom of the filter housing.
(see the photo below)
• To clean the impeller, open the pump housing at the front by sliding up the front plastic
cover.
• The solar module should only be cleaned with soft tissue and glass cleaning solution.
CAUTIONS
• Any altering of the product itself or changing of the components is forbidden.
• Operate the pump in freshwater or saltwater only (never above 30°C).
• Keep it away from flammable liquids.
• Do not strike the solar panel.
• Do not let the pump run dry.
TROUBLESHOOTING
Pump does not operate even though the solar panel is in full sunlight.
• No connection to the solar module—check connection to the solar module.
• Impeller is blocked—to clean the pump, remove the front plate and the impeller,
use a brush or water to remove any debris.
Pump does operate but there is no water running through the tubes.
• Clear the tube and the filter.
impeller
cover
front cover
filter
impeller
WARNING! This product contains chemicals known to
the State of California to cause cancer, and birth defects
or other reproductive harm. www.P65Warnings.ca.gov

Advertisement

loading