UltraLink Products UL-DB2350 Installation

UL-DB2350

Fixed wall Installation

IMPORTANT SAFETY INSTRUCTIONS

Check your TV user manual instructions to
see if there are any special requirements for
mounting your TV. If you do not understand
these instructions or have doubts about the
safety of the installation, assembly or use of
this product, contact:
INTERFOTO CC
Website: www.ultralink.co.za
Email: service@interfoto.co.za
Address: 362 Roan Crescent,
Corporate Park North, Midrand
Tel: +2786 006 1046

1. Unboxing the bracket

- Using the Parts for assembly &
Hardware diagrams,
Inspect the package in order
to ensure that all the parts
have been provided.

Concrete wall installation:

1. Determine the height
and positioning of the wall
bracket.
2. Make sure that the area you
wish to mount to does not
contain any water piping
/internal cables.
3. Draw a marking where you
wish to place your bracket.
2.2.1
2.1 Hold the wall plate against your markings and place the spirit level (Hardware K) above the wall plate, adjust the wall plate until you
get an accurate level then mark your screw holes with a pencil.
2.2 Use an electric drill along with a masonry drill bit. (Mark the drill bit with a piece of coloured tape to create a 60mm mark ,
this will indicate how deep your wall plate hole needs to be drilled.) Then drill into the wall (60mm) to the depth of the coloured tape.
2.2.1 Do not drill wall plate hole into head/bed joint contrete, drill directly onto the header side of the brick.
2.3 Use a hammer to place both wall anchors (Hardware A)
2.4 Position the wall plate and use the spirit level (Hardware K) to insure that the wall plate is leveled.
Use a screw driver & (Hardware B) ST5.3x40mm x 2 to screw in towards the right to tighten screws and secure the wall plate.