E.P.E. Conseil CEMPROTEC 31 Quick Start

Electrosmog Detector
Frequency range from 1 MHz to 10 GHz - Detection 3G / 4G / 5G
EPE Conseil thanks you for purchasing CEMPROTEC. Before use, please read the instructions for use, especially the "Warnings" section. This
section informs you about the warranty period and conditions of use in order to use CEMPROTEC in safety.
•
What is electrosmog?
It is electromagnetic fields that arise during the generation, transport and consumption of technically generated energy.
Electromagnetic fields can be generated by, among other things, cordless devices, such as mobile phones, cordless telephones
(DECT), baby monitors, tablets, Wifi, computers, mobile phone masts or meters (Linky type). "Causes can also be: alternating electric
fields, which are low-frequency fields generated by the alternating voltages in the electrical wiring of a house. Alternating magnetic
fields, which occur as low-frequency fields due to flowing current. This occurs with electrical appliances, high voltages, traction
current of the federal railway or tramway, etc." (Source:
•
Operating the detector
Inserting the battery: Make sure that the battery cable does not come to rest under the battery, but on the side between the battery
and the boundary of the battery compartment.
If this instruction is not followed, the battery compartment may not close properly and the battery cable may be damaged.
Starting up the product: When the product is started up, the battery level is displayed for 3 seconds, then the functions are reset
(initialised) as follows: Loudspeaker: on
Battery indicator: When the product is switched on, the battery level is displayed for 3 seconds on the middle row of LEDs. The other
two are switched off at this moment. The middle row of LEDs indicates the battery level, starting with the red LED. When the battery is
fully charged, the maximum battery level is indicated by the green LED.
Battery-saving function: The unit switches off automatically after 20 minutes to save battery.
Push buttons: Functions activated by push buttons:
· On-Off key press briefly to switch the unit on and off.
· Loudspeaker key: press and hold to manage the loudspeaker.
The table below describes the functions in more detail:
Initial state
Unit switched off
Unit switched on
Loudspeaker on
Loudspeaker off
Display of the frequency strengths:
The 3 LED rows make it possible to indicate the interference levels based on the high-frequency sensor.
All 24 LEDs are used to detect the electromagnetic waves. The lower LEDs indicate the strength of weak radiations, while the upper LEDs indicate the
highest radiations.
Technical data:
Battery operated (9V), non-rechargeable
Maximum current: 50mA
Unit dimensions: 179.5 x 46 x 32.2 mm
Unit weight: 80g
Operating temperature: -10°C +50°C.
Cleaning: To clean the housing, use a soft cloth slightly moistened with rubbing alcohol.
Warnings: CEMPROTEC is not a measuring device, but a search device that allows trends and assessments to be made with regard to electromagnetic radiation. The human body can directly affect the
readings of the detector. For more accurate detections, keep the device at least 50cm away from the body.
The equipment is calibrated in an environment with a temperature of 20°C and a humidity of 45%.
Store CEMPROTEC in a dry place with low humidity.
Any modifications to the unit are not authorised and would invalidate the warranty. Store the unit out of the reach of children.
QUICK START
- HF frequency range - LF frequency range - Magnetic alternating field -
http://www.baubiologie-geppert.de/index.php?Elektrosmog
Action
Briefly press the On-Off button
Press the On-Off key briefly
Press and hold the Select key
Press and hold the Select key
)
Final state
Unit switched on
Unit switched off
Loudspeaker off
Loudspeaker on