Related Manuals for Heininger Destination Gear 5995 Series
Summary of Contents for Heininger Destination Gear 5995 Series
- Page 1 Owner’s Manual Model number FMPPC2-2 58,000 Btu/h Series number 5995 FMPPC2-2_5995.V3 Distributed by HEININGER 1-888-722-5240 | sales@heininger.biz | heininger.biz...
- Page 2 Model number FMPPC2-2, Series 5995 - Tested by CSA International. ANSI Z21.97-2017/CSA 2.41-2017 Outdoor Decorative Gas Appliances DANGER: If you smell gas: 1 Shut off gas to the appliance. 2 Extinguish any open flame. 3 If odor continues, leave the area immediately. 4 After leaving the area, call your gas supplier or fire department.
- Page 3 LP SAFETY: Replacement parts and a list of such parts are available from HEININGER through the contact information provided on the last a. Do not store a spare LP-gas cylinder under or page of this Manual.
- Page 4 All LP cylinders to be used with this appliance must be: WARNING: a. Constructed and marked in accordance with the U.S. Department of Transportation (DOT) Specifications for LP- Ensure that the appliance is kept at a minimum distance of Gas Cylinders, or the Standard for Cylinders, Spheres and 0.91 m / 36 in from the gas cylinder.
- Page 5 PRE-IGNITION INSPECTIONS THE APPLIANCE IS NOT TO BE USED UNTIL ANY LEAK IS CORRECTED. GAS HOSE INSPECTION Clean and inspect the hose before each use of the appliance. A gas appliance repairman or LP gas dealer should be called if attempts to stop the leak(s) are unsuccessful and, in such case, the Attention: If there is evidence of abrasion, wear, cuts, or leaks, LP gas supply must be shut off at the cylinder valve or the cylinder...
-
Page 6: Section 1: Assembly
SECTION 2: IGNITION SECTION 1: ASSEMBLY STEP 1 Enclosed are four bags of rocks, one factory installed 10' STEP 1 propane-rated hose with attached regulator, and one propane tank Ensure that the appliance valve stabilizer ring. dial is in the “OFF” position by pushing and turning clockwise STEP 2 Remove the plastic bags containing the rocks, and set... - Page 7 SECTION 2: IGNITION (continued) STEP 4 STEP 8: TROUBLESHOOTING ***SLOWLY*** turn cylinder valve to the FULLY open position GOT A LOW FLAME?: If your firebowl experiences low flame, or to avoid tripping the CSA excess flow safety device in the gas flame height does not appear to be normally adjusted by the gas regulator.
-
Page 8: Section 3: Periodic Inspection Of Burner Flames
SECTION 3: PERIODIC INSPECTION OF BURNER FLAMES Upon igniting the appliance, If there are no flames present, visually verify that the burner is as demonstrated in the image indeed burning as demonstrated to the left, the appliance is likely in the image to the left. The not burning. -
Page 9: Section 5: Firebowl Maintenance
SECTION 5: FIREBOWL MAINTENANCE REGULAR CLEANING & MAINTENANCE Your Firebowl requires periodic maintenance to keep it in good running order. Follow the steps below to ensure your appliance will provide you with the best possible performance: 1. Keep your Firebowl out of the rain and store it in a dry place when not in use. Your firebowl is made from steel and will naturally form rust if left out in the rain for extended lengths of time. - Page 10 REMOVING INSECT NESTS STEP 4 Remove the gas valve body assembly. WARNING: STEP 5 Small critters like Use a flashlight to look inside the burner tube. Use a long flexible spiders and earwigs pipe cleaner, or long small utensil to clean out any debris or nest can quickly build nests material.
- Page 11 NOTES...
- Page 12 AVAILABLE BY: HEININGER Manufactured by FMI Brands Inc. 107-19052 26 Avenue, Surrey BC, Canada V3Z 3V7 • Toll Free: 1-888-514-1663 The Flame mark is a registered trademark of FMI Brands Inc.
Need help?
Do you have a question about the Destination Gear 5995 Series and is the answer not in the manual?
Questions and answers