Advertisement
Quick Links
Operation Manual
Electric Scarifier 1500 W
63016
Illustration similar, may vary depending on model
Read and follow the operating instructions and safety information before using for the first time.
Technical changes reserved!
Due to further developments, illustrations, functioning steps and technical data can differ insignific -
antly.
Updating the documentation
If you have suggestions for improvement or have found any irregularities, please contact us.
Advertisement
Related Manuals for XPOtool 63016
Summary of Contents for XPOtool 63016
- Page 1 Operation Manual Electric Scarifier 1500 W 63016 Illustration similar, may vary depending on model Read and follow the operating instructions and safety information before using for the first time. Technical changes reserved! Due to further developments, illustrations, functioning steps and technical data can differ insignific - antly.
- Page 2 To allow for a smooth execution of your complaint or return, it is important to contact our cus - tomer service team before returning the goods. Returns Department WilTec Wildanger Technik GmbH Königsbenden 28 52249 Eschweiler E-mail: service@wiltec.info Tel:+49 2403 55592-0 Fax: +49 2403 55592-15 https://www.XPOtool.com Article 63013 Page 2 The Tool Experts 2021-1...
- Page 3 When carrying out maintenance on the machine or if the power cable is pinched or damaged, always switch off the engine and disconnect the power plug from the mains. Wear hearing protection while working. https://www.XPOtool.com Article 63013 Page 3 The Tool Experts...
- Page 4 Have the mains cable replaced by qualified per- sonnel. Only use approved extension cables with appropriate cross-sections. Please consult a quali- • fied electrician if you are unsure. https://www.XPOtool.com Article 63013 Page 4 The Tool Experts 2021-1...
- Page 5 Grass catcher Upper part of the handle Grass catcher cover Handle connecting screw 10 Mains plug Middle part of the handle 11 Mains cable holder clip Lower part of the handle https://www.XPOtool.com Article 63013 Page 5 The Tool Experts 2021-1...
- Page 6 The notches in the upper part of the handle must point inwards (Fig. 3). 3. Connect the middle part of the handle to the lower part using the fastening screws supplied (Fig. 4). https://www.XPOtool.com Article 63013 Page 6 The Tool Experts...
- Page 7 (Fig. 7, 1) to place the grass catcher with the other hand (Fig. 7, 2). The hooks on the grass catcher must slide into the holes in the machine body. Then release the grass catcher cover. https://www.XPOtool.com Article 63013...
- Page 8 Setting too great a working depth can damage the scarifying cylinder or overload and destroy the engine even without visible wear on the blades/springs. This can also damage the lawn. https://www.XPOtool.com Article 63013 Page 8...
- Page 9 Do not clean the machine under running water (especially not by high pressure). Do not use hard or pointed objects to clean the machine. Remove grass and accumulated debris from the wheels, the scarifying cylinder and the cover. https://www.XPOtool.com Article 63013 Page 9 The Tool Experts 2021-1...
- Page 10 If the machine switches off again, reduce the scarifying/aerating depth again, which will reduce the load on the engine. https://www.XPOtool.com Article 63013 Page 10...
- Page 11 D-52249 Eschweiler Important notice: The reprint or reproduction, even of excerpts, and any commercial use, even in part of this instructions manual require the written permission of WilTec Wildanger Technik GmbH. https://www.XPOtool.com Article 63013 Page 11 The Tool Experts 2021-1...