Advertisement
SKINNY DRAUGHT LAGER
SET UP GUIDE
1. FIT THE TAP
3. CONNECT THE KEG COUPLER
(USUALLY ARRIVES ATTACHED)
Connect the blue air
tube to the bottom
of the coupler.
5. PREPARE THE UNIT FOR USE
a) Plug the unit into the mains.
b) Turn the cooling on.
c) Switch the air compressor
on using the switch on the
back of the unit.
Add the drip tray.
Tighten the tap
(counter-clockwise)
using the C Spanner.
Screw the
handle on
to the tap.
Connect the clear
beer tube into the
top of the coupler.
2. CONNECT THE TUBING
Connect the plastic
push fitting into the air
compressor outlet, then
connect the blue air tube.
4. CONNECT THE COUPLER TO THE KEG
a) First ensure the
handle on the coupler
is pulled up.
b) Insert the coupler
into the top of the keg
and turn clockwise.
6. ENJOY SKINNY LAGER
Wait a few minutes
for the beer to chill,
then pour yourself the
perfect pint.
Connect the clear
beer tube into the
beer inlet.
c) Press down
on the handle
to lock.
Adjust flow
if required.
Advertisement
Table of Contents
Summary of Contents for Skinny DRAUGHT LAGER
- Page 1 SKINNY DRAUGHT LAGER SET UP GUIDE 1. FIT THE TAP 2. CONNECT THE TUBING Tighten the tap (counter-clockwise) using the C Spanner. Connect the clear beer tube into the beer inlet. Screw the Connect the plastic handle on push fitting into the air to the tap.
- Page 2 CLEANING GUIDE We advise line cleaning the unit after every use if you do not intend to re-use it again for a while. If you are using the unit every day then you should run a line clean at least every 10 days. How to line clean: RINSE 1.
Need help?
Do you have a question about the DRAUGHT LAGER and is the answer not in the manual?
Questions and answers