LG 42PQ30R Manual page 12

<HDMI 1 : 256bytes>
<HDMI 2 : 256bytes>
<HDMI 3 : 256bytes> SIDE HDMI(HDMI 3) is adjusted above
60Tool model
6. HDCP(High-Bandwidth Digital
Contents Protection) Download
HDCP download process is deleted in H6 models
In H6 models, it is usimg the EEPROM masking HDCP Key
Copyright©2009 LG Electronics. Inc. All right reserved.
Only for training and service purposes
7. Manual ADC Adjustment
(Component 1, RGB)
[Caution]
- Do not connect external input cable
- Adjustment result is applied to SET On/Off later.
RF input
NO SIGNAL or White noise
* Adjustment is done using internal ADC, so input signal is not
necessary.
7-1. COMPONENT ADC (SD / HD)
(1) Convert to Component1 input source.
(2) Press ADJ key on R/C for adjustment.
(3) Enter Password number. The value of Password is "0 0 0
0".
(4) Select "0. ADC calibration" by using
ENTER( ).
V
(5) Start ADC adjustment by using
ENTER( ).
V
(6) ADC adjustment is executed automatically .
When ADC adjustment is finished, this OSD appear.
7-2. RGB input ADC
Auto RGB Gain/Offset Adjustment
(1) Convert to PC in Input-source
(2) Press ADJ key on R/C for adjustment.
(3) Enter Password number. The value of Password is "0 0 0
0".
(4) Select "0. ADC calibration" by using
ENTER( ).
V
(5) Start ADC adjustment by using
ENTER( ).
V
(6) ADC adjustment is executed automatically .
When ADC adjustment is finished, this OSD appear.
Notice :
After All mode check, set the Speaker Volume "0".
- 12 -
AV / Component / RGB input
NO SIGNAL
/ (CH +/-) and press
D E
/ (VOL +/-) or press
F G
/ (CH +/-) and press
D E
/ (VOL +/-) or press
F G
LGE Internal Use Only