Sony VPCZ21L9E/B User Manual page 94

Using Your VAIO Computer >
Using the TPM
Configuring the TPM
To use the embedded TPM, you need to:
1 Enable the TPM in the BIOS setup screen.
2 Install the Infineon TPM Professional Package.
3 Initialize and configure the TPM.
To enable the TPM in the BIOS setup screen
1 Turn on the computer and press the F2 key repeatedly until the VAIO logo disappears.
The BIOS setup screen appears. If the screen does not appear, restart the computer and try again.
!
The VAIO logo does not appear when Fast BIOS Startup Settings on the VAIO Control Center is enabled. Disable the settings with the VAIO Control
Center (page 163).
2 Press the < or , key to select the Security tab, the M or m key to select Change TPM State, and then the Enter key.
Press the M or m key to select Enable and then the Enter key.
3
4 Press the < or , key to select Exit, select Exit Setup, and then press the Enter key.
5 After your system restarts, select Execute in the confirmation window and then press the Enter key.
✍
You can also disable the TPM and clear the TPM configuration in the BIOS setup screen.
!
Before enabling the TPM, be sure to set the power-on password to protect against unauthorized modification of the TPM configuration.
If the TPM is enabled, it will take longer before the VAIO logo appears due to security checks at computer startup.
You will not be able to access any TPM-protected data if you clear the TPM ownership. Before clearing the TPM configuration, be sure to make backup
copies of the TPM-protected data.
n 94 N