Download Print this page

Advertisement

Quick Links

Mendip
[01] x 1
[02] x 1
[03] x 1
[05] x 1
[06] x 1
[07] x 1
[09] x 2
[10] x 1
[11] x 1
[13] x 1
You will need
Before you start
This tap is suitable for use at water supply pressures of
0.5 bar (min.) to 5 bar (max.).
This product must be connected to the water supply in
accordance with the UK Building Regulations. If you are in
any doubt about these requirements,contact a qualified
plumber,your local Water Company, or the Water
Regulations Advisory Scheme(WRAS).
(a) Identify all components and check pack contents.
(b) Turn off mains water supply. The main stopcock is
usually situated where the supply enters the buiding
(c) It is also recommended that the water heating
arrangements are turned off.
(d) Drain the cold and hot water system. It is recommended
to ensure complete drainage,that all taps are opened.
There is no need to drain the heating system.
After Care
Ensure the tap is fully turned off after use.
[04] x 1
To maintain the appearance of this fitting, ensure it is
cleaned only using a clean soft damp cloth. A solution of
warm water and mild liquid detergent may be used where
necessary and then rinsed thoroughly.
[08] x 2
Abrasive cleaners or acidic cleaners MUST NOT BE USED
under any circumstances
Avoid contact with solvents.
Manufacturer's guarantee
[12] x 1
This tap is guaranteed to be free from faults arising from
manufacturing defects for a period of 10 Years from the date
of purchase
Retain proof of purchase.
Caution
Contains parts which if these become loose could be a
choking hazard to small children. After installation please
check that the bar levers into the tap heads and the plug
lift rod are secure, if required please use low strength
thread lock to secure these parts.
Please pass these instructions back onto householder for
retention for future reference.
Do not over bend the flexible hoses.
NOTE!
max.
3Nm
min.
80mm
min.
15mm
Kingfisher International Products Limited,
3 Sheldon Square, London, W2 6PX,
www.kingfisher.com/products
Kingfisher International Products B.V.
Rapenburgerstraat 175E
1011 VM Amsterdam
Please retain for future reference.
UK Manufacturer:
United Kingdom
www.screwfix.com
EU Manufacturer:
The Netherlands
www.screwfix.ie
V10621 BX220IM

Advertisement

loading

Summary of Contents for screwfix Mendip

  • Page 1 Caution Before you start Mendip Contains parts which if these become loose could be a choking hazard to small children. After installation please This tap is suitable for use at water supply pressures of check that the bar levers into the tap heads and the plug 0.5 bar (min.) to 5 bar (max.).
  • Page 2 Please check sink thickness before installing. No. (05) mounting seat is not needed if the thickness is more than 35mm. [10]x1 [01]x1 [11]x1 [05]x1 [02]x1 [04]x1 [03]x1 A. Filter B. Hot C. Cold [06]x1 [09]x2 [07]x1 57mm [08]x2 [13]x1 5~6mm Not Included...
  • Page 3 Filtration control Filter replacement [12] x1 unfiltered filtered hot/cold water water Press to filter the water Replace filter every 6 months! Regular water flow control A. Hot B. Cold C. Inlet D. Outlet 1.Pull the handle out to, turn on and to control the flow.