Summary of Contents for Robotics Technologies EL 500
- Page 1 EL 500 RFID Electronic Cabinet Lock User Guide © All content Copyright 2019-2020, Robotics Technologies, Inc., and is subject to change.
- Page 2 If the Master Code is incorrect, the Red LED will blink 4 times, and the system will exit Program Mode. If the Master Code is correct, the Green LED will blink 3 times, to prompt the entry of the User/Parameter location. © All content Copyright 2019-2020, Robotics Technologies, Inc., and is subject to change.
- Page 3 Lockout Time in seconds. Enter the New Tamper Lockout Time (default is 300 Seconds) The Green LED will blink 3 times, to prompt the entry of the next User/Parameter location. © All content Copyright 2019-2020, Robotics Technologies, Inc., and is subject to change.
- Page 4 Enter 999. The Red and Green LED will blink twice, and the system will exit Program Mode If there is no activity on the Keypad for 1 minute, the system will automatically exit Program Mode © All content Copyright 2019-2020, Robotics Technologies, Inc., and is subject to change.
- Page 5 That sequence continues indefinitely. The Reader Head is not fully plugged into the control unit The Reader Head is faulty A failure in the Lock Control © All content Copyright 2019-2020, Robotics Technologies, Inc., and is subject to change.
- Page 6 All User Codes will be erased. ▪ Dual Mode will be disabled. ▪ Tamper-lockout time will be set to 300 seconds. ▪ Auto-lock will be disabled. ▪ © All content Copyright 2019-2020, Robotics Technologies, Inc., and is subject to change.
- Page 7 Communication Cable. Connects the Lock Control Unit to the Communication Interface Board. Communication Interface (located on rear wall of the cabinet). Used to communicate to a computer via a CartTrak USB Interface for auditing and control (sold separately). © All content Copyright 2019-2020, Robotics Technologies, Inc., and is subject to change.
Need help?
Do you have a question about the EL 500 and is the answer not in the manual?
Questions and answers