Essentials Bluetooth Round User Manual page 27

on the valve. After installation, press the pair button to run ad-
aptive.
The display of „AdA" (adapting run) with the rotating shows
that an adapting run to adapt the thermostat to the valve.
If the adapting runs is initiated before installation, press pair
button and the motor travels back to the „InS" (Install) position.
If an error message(F1,F2,F3) is displayed, press the Pair/Boost
button and the motor similarly travels back to the „InS" (Install)
position.
4 Installation
The radiator thermostat is easy to install and can be done wit-
hout draining heating water or intervening in the heating sys-
tem. No special tools are required, nor does the heating have
to be switched off.
The ring nut attached to the radiator thermostat can be used
universally and without accessories for all valves with a thread
size of M30 x 1.5 from the most popular manufacturers such as:
Danfoss, Heimeier, MNG, Junkers, Landis&Gyr (Duodyr),
Honeywell-Braukmann, Oventrop, Schlösser, Comap,
Valf Sanayii, Mertik Maxitrol, Watts, Wingenroth (Wiroflex),
Idmar54, R.B.M, Tiemme, Jaga and Siemens.
By means of the adapters in the delivery, the device can be in-
stalled on radiator valves of type Danfoss RA, Danfoss RAV and
Danfoss RAVL.