Plyroom Ava Lifestages Assembly Instructions

P L Y R O O M
Ava Lifestages Cot
Thank you for choosing this product to be a part of your home. Each Plyroom piece is made for life
from sustainably forested materials. Your choice is helping support environmental initiatives through our
contribution of 1% of our sales revenue to 1% for the Planet.
A S S E M B L I N G Y O U R F U R N I T U R E
→ Do
We ask that you take your time in assembling this piece of furniture. All pieces are
designed to lock together with precision.
Use a mallet to press mortise and tenon joins together so they are flush. If you don't
have a mallet a hammer covered with a soft towel is fine.
Check all joins are flush before inserting the oak dowels.
Use a hammer to tap dowels in and fasten pieces together. Make sure the dowel is
straight before you hammer.
→
Don't
Use a mallet on the timber dowels as the soft head of the mallet will cause them to
snap.
Share your space with us #plyroom
@plyroom
www.plyroom.com.au
I N T E N T I O N A L L Y S I M P L E
& H O N E S T D E S I G N
This product is designed with a modern interpretation of mortise and tenon joinery,
the oldest and strongest form of joinery used by carpenters for thousands of years.
The precise interlocking parts are displayed throughout, and the pieces fit together
like a jigsaw, emphasising the characteristics of the natural materials used.
Each mortice and tenon join is locked in place with a
handmade oak dowel.
M I N I M A L P A C K A G I N G
You might notice that your item is packaged simply. This is intentional to minimise
waste as much as possible. The plastic wrapping used can be recycled at many
recycling centres rather than going to landfill.
P R O D U C T C A R E
For general care we recommend dusting with a clean, dry cloth, or wiping down
with soft cloth wrung dry from plain water (leaving the surface dry after cleaning).
Avoid detergents or solvents of any type.
I M P O R T A N T !
→
Disassembling your frame
This piece is designed to be disassembled when required. Please note that when
disassembling, a hammer must be used to remove the dowels. ALWAYS hold the
hammer in line with the grain of the timber panel it fastens and use the prongs of
the hammer to lever the dowel out slowly. If this step is not followed it will result in
breakage of the dowel.
Once the timber dowel is removed the mortise and tenon pieces will come apart
with some gentle tapping with a mallet.
This product has been designed and made by
Totem Italia exclusively for Plyroom.