Table of Contents
Advertisement
LED signalling cont.
Restore factory settings
In case of lack of access to the controller, for example due to
lost passwords, it is recommended that you reset the access
passwords and then reconnect and configure the controller
using the Fox application.
To reset passwords:
1. While the controller is operating, press and hold the PROG
button on the front of the controller. When the button is pres-
sed, the green LED will start to flash rapidly.
2. After about 5 seconds, the LED will turn off and you should
release the PROG button.
3. Press the PROG button briefly, the green LED will light up aga-
in.
4. Press and hold down the PROG button. After about 3 seconds,
the previously switched on green control light will start to fla-
sh. After another three seconds, it will go out.
No connection
to Wi-Fi network
Restoring firmware
- 14 -
Advertisement
Table of Contents
