Advertisement
Using these instructions
Please refer to all safety and installation requirements
detailed in the Quick start guide provided with the
HydroTap Command Centre, and HydroTap Command
Centre installation instructions found online, prior to
installation of, or any change to, the complete system.
Before commencing the
!
installation,download
& read the HydroTap
Read the
WARNING
Command Centre
instructions
installation instructions
Tools needed for tap installation (not supplied)
InLine
E L E C T R O N I C
In addition to normal tools, the following (or equivalent
equipment) will be required
.
35mm diameter sheet metal hole punch for sinks.
•
35mm diameter hole saw for worktops.
•
Tube spanner for fixing the tap assembly.
•
Be aware of the risks of hazards which could
!
cause harm when using tools. Assess the
risks before starting the installation.
Water supply pressure requirements
Min - Max pressure, kPA (bar)
HydroTap
170 (1.7) - 700 (7.0)
Sparkling
250 (2.5 ) - 700 (7.0)
HydroTap
Booster
200 (2.0) - 700 (7.0)
1
Positioning
Position the tap such that it dispenses into the
sink bowl with clearance for a cup or tea pot.
Ensure that taps are positioned to minimise
!
the risks of scalding by dispensing boiling
water while using the tap.
Position Command Centre
and Tap as close together as
possible. See below.
2
Familiarise yourself with the mains
connections
Fit braided hoses, matching
the hose colours to the tap
6
See
Mains
Cold
3
Familiarise yourself with the tap connections
Boiling models
220mm
RED
Boiling
tube
CLEAR
Vent
tube
USB
4
Cut the hole
Chilled sparkling
model shown
Cut a Ø35mm hole in the worktop / sink.
•
• Make sure the tap location will allow the tap
spout to drain into the sink.
5
Mount and secure the tap
Brass
washer
6
See
Mains
Hot
Sparkling models
BLUE
Chilled
tube
BLUE
JG
pipe
WHITE
JG
pipe
USB
Ø35mm
Upper rubber
washer
Lower rubber
washer
Fixing nut
Advertisement
