Safety Guards; Maintenance - TESY LD-168D Technical Description And Operations Manual

Table1 illustrates the smallest possible dimensions of
the room to be heated and the aperture's dimensions
for the upper and lower levels in accordance with the
maximum, medium, and low power outputs.

SAFETY GUARDS:

• The first protection device is applied in order to
prevent the potential risk of fire, that's why its parts
must never be removed. The protective device does
not offer full protection to children or persons with
ailments.
• The second protective device will turn off the
heater if it is tipped over, if this activate, set the
heater upright, check for obvious damage and again
wait 5-10 minutes before attempting to re-light the
heater.
Important! The mobile gas heater is not intended to be
used on natural gas.
This appliance has been manufactured for TESY Ltd,
Shumen, 48 Madara Boulevard (P.O. Box 529) by
Jiasheng (Zhongshan) Electrical Appliances Co., Ltd.
This is an I3B/P(30) category appliance with maximum
power output of 4.2 kW and fuel consumption of
305 g/hour. This appliance works with propane butane
gas (G30/31) with a pressure of 30 mbar. The amount of
air required for the correct burning process is 8,4 m3/h.
INSTRUCTIONS FOR USE:
Lighting the heater
1. connect heater to the gas bottle fettle with 28 - 30
mbar Butane: propane regulator;
2. turn on tap gas bottle;
3. position the control knob to
press the control knob and hold down for 10 sec.,
then press the red button with the lighter symbol
, in order to produce a spark (in case the pilot flame
fails to ignite, press the red button again, and keep
holding down the control knob); keep pressing the
control knob for another 20 sec., so the thermostat
will have time to warm up, then turn the control
knob to the desired position:
start - Control flame
- Low flame /low gas consumption/low
heating power
- Medium flame /medium gas consumption/
medium heating power
- High Flame /high gas consumption/
maximum power
English
Extinguishing the heater:
Stop the gas from the canister's outlet valve. The heater
shall be "fully switched off" only if the canister's outlet
valve is fully closed.
this is not the case, close the valve and contact a service
center.

MAINTENANCE:

Check the flexible pipe's elasticity on a regular basis.
In case the flexible pipe becomes damaged or worn, it
must be replaced with a new pipe - 450 mm length, in
compliance with the local national standards. For your
personal safety, change the flexible pipe once every five
years.
Clean the appliance's surface with a soft damp cloth.
The dust and residues on the inside of the appliance
may be cleaned with a vacuum cleaner while the heater
is switched off. Protect the signs from damage.
When the heater is not in use for a long period you must
remove the gas bottle and it should be covered and
stored in a dust-free place.
Major servicing should be carried out every 1 - 2 years.
start (control flame),
Table1:
V - room's dimensions, S - room's apertures
Ignition
Important! When the control button is set to one of its
end positions, it must return to its initial raised level. If
V
15 m³
28,5 m³
42 m³
Environmental protection
Discarded electrical appliances are recyclable and
should not be disposed of with the domestic waste!
Please actively support us in conserving resources
and protecting the environment by returning this
appliance to the collection centres (if available).
Usage and Storage Instructions
EN
S
105 cm²
105 cm²
105 cm²
3