Operative Experience Tactical Hemorrhage Control Trainer Quick Start Manual

Tactical Hemorrhage
Control Trainer
1
Equipment Identification
+ +
Simulator
and Charger
3
Install Battery
+
To install the battery pack, remove the skin cover on the
upper left thigh to access and open the compartment.
Then, attach the pack to the connector, and after resetting
the pack in the compartment, close the compartment
and replace the skin.
+
Battery Pack Hand Pump
(for blood)
QUICK START GUIDE
To get started, please follow these easy steps:
2
Charge Battery
+
Plug into a standard electrical outlet. The red light
indicates charging.
+
Charge the batteries for 6 to 8 hours (or overnight).
The indicator light turns green when the batteries
are fully charged.
4
Add Blood to the Simulator
+
Fill the reservoir on the hand pump with simulated blood.
+
Lift the penis and extend the blood fill port.
+
Attach the blood fill hose by snapping onto the blood fill
port on the simulator located under the penis. (Be sure the
hose nozzle if free of debris.)
+
Retract the handle and pump approximately three times or
until the simulator's blood reservoir is full.