Switching Off Water Softening; Softening System Regenerative; Run - Bosch SGV2ITX22E User Manual

When using for the first time: fill the
2.
reservoir completely with water.
3. Note: Only use special salt for
dishwashers.
Do not use salt tablets. Do not
use table salt.
Place the softening salt in the
softening salt reservoir.
Funnel
1
Fill the water softening salt
reservoir completely with softening
salt. The water in the reservoir is
displaced and flows away.
Fit and close the lid of the
4.
reservoir.
Switch off water softening
If the refilling salt display bothers you,
for example if you use a combined
dishwasher detergent with a salt
component, you can switch off the
display.
Remark
To avoid damage to the appliance,
only switch off the water softening
in the following cases:
s The water hardness is a maximum
of 21 °dH and you use a combined
dishwasher detergent with salt
substitutes. combined
Depending on the device version
1
s The water hardness is 0 - 6
1.
2.
a
a flashes in the display.
3.
4.
a The water softener has been
Regenerate the softening
system
In order to maintain trouble-free
operation of the softening system,
the device regularly performs a
regeneration of the softening system.
The softening system is regenerated
in all programs before the end of the
main wash cycle. This increases the
running time and the consumption
values of, for example, water and
electricity.
Softening System NL
According to the manufacturer's
instructions, you can only use
dishwasher detergents with salt
substitutes up to a degree of
hardness of 21 °dH without adding
softening salt.
°dH. You do not need to use
softening salt.
on to press.
To access the device settings,
press . for 3 seconds
to press.
Press as many times until there
no more LED lights up (position 0).
→ "Overview of the water hard-
health settings", page 21
To save the settings, press for
approx. 3 seconds.
switched on and the refilling salt
indicator is deactivated.
23