Page 2
* Extruded Aluminum heat sink housing. * All connections made on rear panel, all adjustments made on front panel. SRS1000 Theater Sound Owner's Manual SRS1000 Theater Sound Owner's Manual Congratulations!!! ----- 1 -----...
Page 3
* TV low level input (RCA L/R) * TV high level input (3.5mm mono jack) * Radio high level input (8 pin Molex, locking type) for Radio speaker feed direct SRS1000 Theater Sound Owner's Manual SRS1000 Theater Sound Owner's Manual ----- 2 -----...
Page 4
1998 SRS Labs, inc. All Rights Reserved. SRS, the SRS logo, Sound Retrieval System are registered trademarks of SRS Labs, Inc. All other corporate and brand names are trademarks of their respective holders. SRS1000 Theater Sound Owner's Manual SRS1000 Theater Sound Owner's Manual...
Page 7
8. 10 kHz Band Adjustment---Adjust high frequency response (Treble) of the amplifier when in TV mode .This control has no effect on radio mode. SRS1000 Theater Sound Owner's Manual SRS1000 Theater Sound Owner's Manual Front panel view 3D-Field...
Page 8
Do not connect any cable to the TV In ,Hi Level Jack if this input is used . 4.Line in ,Radio--Connect to variable line output from radio (if available). Do not connect the 8 pin harness to the SRS1000 if this input is used. 5.Main Connection Input. Use included 16 pin wire harness to apply power, TV mode trigger, and all speaker outputs though this connection.
Page 10
First Time Operation Important: Before Applying Power: a) Set all controls on SRS1000 to mid position (slot in knob will be vertical). b) Be sure TV mode trigger is not active (ie: 0 VDC) c) Be sure that TV and Radio are off System Set-Up (Gain Matching, EQ setting, 3D Effect setting) 1) Apply power to SRS1000.
Page 11
8) Adjust 3D Effect knob to match size of vehicle. This control is to compensate for the acoustic properties of small and large vehicles, which are very different. As a gengeral rule of thumb, the smaller SRS1000 Theater Sound Owner's Manual SRS1000 Theater Sound Owner's Manual ----- 6 -----...
Need help?
Do you have a question about the SRS1000 and is the answer not in the manual?
Questions and answers