Summary of Contents for Hidro-Water NEREO
- Page 1 RESIDENTIAL REVERSE OSMOSIS USER / INSTALLER’S MANUAL MA-EN-OSMOSIS NEREO-RO-0206-XX-PSM-21-V01.0...
-
Page 2: Table Of Contents
• For the correct operation of NEREO osmosis systems, the pressure should be between 2,5 - 4 bars 4.3.- Drain clamp installation (Figure-12) ................... 7 for an osmosis system without pump and between 1 – 3 bar for an osmosis system with pump. If the pressure is greater than 4 bars in an osmosis system without pump and greater than 3 bar in 4.4.- Cartridge installation ........................ -
Page 3: Checking The Contents
• The NEREO with pump osmosis system needs a mains current of 220 – 240V less than 1 metre away. • Do not repair or take the system apart on your own. If the system is not working correctly, contact your distributor. -
Page 4: Installation
The system can be installed anywhere in the residence where there is a water input, a drain a. The drain clamp is designed to adjust the sealing for wastewater, a 220 – 240 V (only NEREO osmosis system with pump) socket within a metre and drainpipe to 1 ½”. -
Page 5: Membrane Installation (Figure-7)
Here are the steps to follow to make the hydraulic connection: be able to open the membrane housing cap. NEREO NEREO WITH PUMP a. Place the osmosis system and storage tank (Figure-6) in the chosen location. - Page 6 The other end of the ⅜” tube should be inserted through the inline postfilter’s “T” nut. Then k. Plug the NEREO with pump osmosis system into an electrical outlet of 220 – 240 V. after putting a corresponding ⅜” plastic insert, screw the nut back on.
-
Page 7: Osmosis System Start-Up
This product isn’t dangerous but could affect the taste. Repeat this task twice more. a. Make sure that all the connections are connected properly and tightened. Also, make sure the water inlet is closed. For NEREO osmosis system with pump connect it to a h. Turn the faucet off. -
Page 8: Procedure For Replacing Cartridges And The Membrane
I in point 5 of this manual. NEREO NEREO WITH PUMP Precaution 4: When you change the inline postfilter (5 stage), if the water runs with a blackish colour, do not worry, this is normal. -
Page 9: Troubleshooting
Damaged shut off valve. Replace shut off valve. Non-return valve Bitter or Replace non-return valve* Water with very low salinity level. Fit a mineralizing postfilter. acidic taste deteriorated* * Only equipment with pump * Only equipment with pump MA-EN-OSMOSIS NEREO-RO-0206-XX-PSM-21-V01.0 MA-EN-OSMOSIS NEREO-RO-0206-XX-PSM-21-V01.0... -
Page 10: Monitoring And Maintenance Control
Sediments, GAC y CTO cart. change Membrane change Membrane change Postfilter change Postfilter change Sanitization Sanitization Reparation Reparation Name and signature of the authorised technician or distributor: Name and signature of the authorised technician or distributor: MA-EN-OSMOSIS NEREO-RO-0206-XX-PSM-21-V01.0 MA-EN-OSMOSIS NEREO-RO-0206-XX-PSM-21-V01.0... -
Page 11: Spare Parts
OI-0207-07 Shut off valve OI-0207-09 2 ½” Simple clamp PO-0203-01 18x12 Membrane housing OI-0234-06 NEREO Inlet elbow piece for the pressure gauge OI-0234-04 NEREO Pressure gauge ME-2002-02 18x12 Membrane 50 GPD OI-0206-08 1/8” M x ¼” T elbow piece OI-0207-117 1/8”... -
Page 12: Osmosis System With Pump
Shut off valve OI-0207-09 2 ½” Simple clamp PO-0203-01 18x12 Membrane housing OI-0234-14 NEREO with pump Inlet elbow piece for the pressure gauge OI-0234-12 NEREO with pump Pressure gauge ME-2002-02 18x12 Membrane 50 GPD OI-0206-08 1/8” M x ¼” T elbow piece OI-0207-117 1/8”... - Page 13 Hidro Water, S.L.U. Carretera Chirivella-Aldaya, 48 46960 Aldaya · Valencia, Spain Tel: (+34) 961 98 62 30 hidrowater@hidro-water.com www.hidro-water.com DISTRIBUTOR INSTALLER Sale date Instalation date Stamp: Stamp: MA-EN-OSMOSIS NEREO-RO-0206-XX-PSM-21-V01.0...
Need help?
Do you have a question about the NEREO and is the answer not in the manual?
Questions and answers