Advertisement
INSTALLATION INSTRUCTIONS
To remove the drawer:
‰ Slide the drawer out on the rails until fully extended.
‰ Press both release latches as shown, then pull the drawer toward you, off the rails.
‰ Lift the drawer out from the vanity.
To reinstall the drawer:
‰ Fully extend the rails.
‰ Align the holes on the rear of the drawer with the hooks on the rails and tilt into place.
‰ Push the drawer closed and continue to push until you hear both rails "snap" into place.
‰ Ensure the drawer is locked into place by opening the drawer and lightly lifting the front of the drawer
upward. If the drawer does not lift up, it is engaged. If the drawer lifts up, repeat the above procedure.
‰ Slide the drawer in and out of the vanity to ensure smooth operation.
Adjustment:
‰ Slide the drawer out on the rails until fully extended.
‰ Turn the black cam one quarter turn counter clockwise to unlock.
‰ For horizontal adjustment, turn the grey cam clockwise or counter clockwise as needed.
‰ For vertical adjustment, turn the blue cam(s) clockwise or counter clockwise as needed.
‰ Re-lock the black cam after adjustments are made.
1158696_2_A
6 of 6
Wooden Vanity & Pre-Cut Marble Top
7. REMOVE/ADJUST THE DRAWERS
Release Latch
Grey Cam
Blue Cam
Black Cam
Blue Cam
Questions? Problems? For additional assistance, please contact KALLISTA's Customer
Service Department at 1-888-4KALLISTA (1-888-452-5547) or FAX 1-888-272-3094.
Advertisement
