Table of Contents
Advertisement
P
1: IR C
A RT
There are 2 ways to control the VideoReQuest via IR. The simplest method is to use a
handheld remote aimed at the IR receiver on the front of the unit. For more advanced
installations, there is a 1/8
based control systems. No matter which method you choose, this portion of the document
will describe the commands available.
R e a r I R P i n o u t
The rear IR jack is designed for a 2 conductor 1/8
block or control system. You CAN NOT plug a dinkylink directly into the back of the
VideoReQuest.
2 Conductor Pinout
Tip
Signal
Ring
Ground
Sleeve
Not Connected
L e a r n i n g I R C o d e s i n t o O t h e r S y s t e m s
For any advanced commands (2 button key combinations), the proper method for teaching
the system the VideoReQuest IR codes is as follows:
1. Aim the VideoReQuest Remote AWAY from the learner
2. Press AND HOLD the Alt or Shift button (depending on command)
3. Aim the remote AT the learner
4. Press the second button
5. Release BOTH buttons
Most advanced commands are written on the IR remote in GREEN text. To access these
commands, press and hold the Alt button prior to pressing the desired command button.
Other advanced commands not written on the remote are listed in the table below.
L i s t o f A d v a n c e d I R C o m m a n d s
Action
Description
Refresh DVD Details
Performs a lookup on the current DVD
Phone (518) 899-1254 • Fax (518) 899-1251 •
ONTROL
th
inch mini jack on the rear of the unit for integration with IR
-
VideoReQuest Protocol Guide v1.1.2 - 5/18/04
th
inch mini plug from a powered connecting
www.request.com
2 -
nd
Alt/Shift
2
Button
ALT
EDIT
Advertisement
Table of Contents
