PheeNet WAS-854NP Firmware Release Notes

Advertisement

Quick Links

Model: WAS-854NP
Previous Version: V1.1.4
Newly Version: V1.1.5
***Attention: please read it carefully before you upgrade the firmware.
1. Please back up your system configuration prior to the upgrade in case any system errors
occur.
V1.0.6
6 Apr. 2011
V1.0.7
4 May 2011
V1.1.0
5 Oct. 2011
V1.1.1
9 Nov. 2011
V1.1.2
23 Dec. 2011 1. Fixed Wireless can't connect to AP, when admin enable 1-4
13 April 2012 1. Add "Connect Time" and "TX/RX Bytes" information on
V1.1.3
V1.1.4
22 May 2012 1. Add Noise information on AP List

Firmware Release Note

1. Change 『Group Key Update Period』 and 『Master Key
Update Period』setting range from 10-99999999 to
0-99999999
2. Fixed throughput box issue on status page for IE9
1. Fixed WDS's Description can't save problem on WDS Mode
2. Add alert message on WDS Setup page on WDS Mode,
when the Channel is 『Auto』
3. Remove Auto Channel option on WDS Mode
4. When operating mode change from AP Mode to WDS
Mode, the Channel will change from 『Auto』 to 『6』
5. Change time out on WDS connection
1. Fixed Txpower issue
1. When Controller send empty ESSID and Host Name to AP,
the AP will use original setting
WDS and set Maximum Client to 1-4 on VAP page
2. Add VLAN tag over WDS via VAP
3. Add VLAN setting page and change VLAN setting on VAP
settings
4. Change IAPP GUI setting, IAPP only support WPA2
encryption
Associated Clients Status page
2. Support AP Management by WMS-308N FW V1.0.1
2. Adjust discovery mechanism for AP Management
Date: 27 July 2012

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the WAS-854NP and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for PheeNet WAS-854NP

  • Page 1 Firmware Release Note Date: 27 July 2012 Model: WAS-854NP Previous Version: V1.1.4 Newly Version: V1.1.5 ***Attention: please read it carefully before you upgrade the firmware. 1. Please back up your system configuration prior to the upgrade in case any system errors occur.
  • Page 2 3. Fixed the device can't connected via wired when VAP enable VLAN tag V1.1.5 27 July 2012 1. Change ACL log on Event Log page when system receive ACL control message from AP management 2. Add auto disconnect when system receive the block message of ACL from AP management...

Table of Contents