Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Summary of Contents for Glide O2
- Page 1 I N F L A T A B L E B O A R D U S E R M A N U A L...
-
Page 2: Pump Maintenance
RECCOMENDED PRESSURE 12-14 PSI Glide boards can hold up to 25 PSI, however, the recommended PSI is 12-14 PSI as the board will remain rigid at 14 PSI and no further benefit is gained when inflating over 14 PSI. -
Page 3: Transport Guidelines
TRANSPORT GUIDELINES TIPS FOR TRANSPORTING When transporting the board, be sure to clear any sharp objects. Punctures are not covered by the manufacturer's warranty! Keep the board clear of any heat producing items such as camp stoves, propane lamps, etc. Damages resulting from heat are not covered by the manufacturer's warranty! Allow the board to completely dry before tightly rolling for... -
Page 4: Water Safety Guidelines
IMPORTANT WATER SAFETY GUIDELINES ALWAYS WEAR A COAST GUARD APPROVED PERSONAL FLOTATION DEVICE (PFD). NEVER GO PADDLE-BOARDING IN SEVERE WEATHER OR WATER CONDITIONS THAT MIGHT AFFECT YOUR ABILITY TO STEER THE BOARD OR RETURN TO SHORE. NEVER ALLOW MINORS TO USE THIS BOARD WITHOUT ADULT SUPERVISION. - Page 5 INFLATING AND DEFLATING BOARD BOARD INFLATION Make sure the inner valve is disengaged in the "UP" position Connect air hose to air valve Set Action Control setting on pump to the right and begin pumping Once pumping becomes difficult, switch the control to the left Inflate board to 12-14 PSI Disconnect air hose from valve.
-
Page 6: Fin Installation
FIN INSTALLATION We have a simple fin installation walkthrough video - here... - Page 7 ADJUSTABLE TRAVEL PADDLE PADDLE ASSEMBLY For convenience, the paddle can be separated into 3 smaller sections and has an adjustable locking mechanism for an extendable handle. IMPORTANT We recommend rinsing the paddle with fresh water after every use and removing upper shaft to dry.
- Page 8 REPAIR KIT CONTENTS AND APPLICATION REPAIRING LEAKS AND TEARS THE REPAIR KIT The board comes with equipped with an emergency repair kit for small leaks and/or tears including a valve wrench, glue and repair patches. The wrench included in the repair kit should ONLY be used for leaking valves. Should you hear air escaping around the edge of the valve please ONLY use to tighten by turning clockwise and ONLY when the board is fully inflated.
-
Page 9: Warranty Information
WARRANTY INFORMATION All of our warranty information is here CONTACT US: PHONE: 888-927-9405 EMAIL: info@glidesup.com FAQS MY PADDLEBOARD HAS A SLOW LEAK, WHAT SHOULD I DO? HOW SHOULD I STORE MY BOARD? Check that the inflation valve is tight. The vast You can store your board in a variety of ways.