Do you have a question about the AIR-PLUS 691164 and is the answer not in the manual?
Questions and answers
Summary of Contents for AllTrade AIR-PLUS 691164
Page 1
#540020 Air Nailer/Stapler Operation Manual #691164 #691165 It is the owner and/or operator’s responsibility to study all WARNINGS, operating, and maintenance instructions contained on the product label and instruction manual prior to operation of this unit. The owner/operator shall retain product instructions for future reference.
The owner and/or operator is responsible for maintenance, maintaining all decals or warning labels and while in use, maintaining the unit in good working order. If the owner and/or operator is not fluent in English, French or Spanish, the product warnings and instructions shall be read and discussed with the operator’s native language by the purchaser/owner or his designee.
Page 3
NAILER/STAPLER SPECIFICATIONS Compressed Air: Maximum permissible operating pressure: Recommended operating pressure range: Magazine Capacity: Rotatable Exhaust Cap Work Contact Element (WCE) 120PSI (0.8 MPa) 60-100PSI (0.4-0.7 MPa) Approx.100 Brad Nails/Staples Trigger Nail/Staple Loading Area Discharge Area Air and Oil Inlet Quick Release Latch...
NAIL/STAPLE INFORMATION Fastener Gauge Fastener Lengths NAILS: Can use brad nails from the following branded air-powered brad nailers: Bostitch NB0030, Paslode ® T125-F18, Porter Cable STAPLES: Can use staples from the following branded air-powered staplers: Porter Cable Bostitch ® is a registered trademark of The Stanley Works Campbell Hausfeld ®...
UNPACKING & INSPECTION WARNING Do not operate this air nailer/stapler if damaged during shipment, handling or mis- use. Damage may result in bursting, which can cause serious injury or property damage. All damaged parts must be repaired or replaced as needed prior to operating this air nailer/stapler. If you have any questions, or require assistance with damaged or missing parts, please contact our customer service department at: Please have the serial number, model number, date of purchase, and parts list, (with missing parts...
Page 6
USE COMBUSTIBLE GASSES OR ANY OTHER REACTIVE GAS AS A POWER SOURCE FOR THIS NAILER/STAPLER. Explosion and serious personal injury could occur. • Use clean, dry, regulated, compressed air at 60 to 100 PSI (0.4 to 0.7 MPA). Do not connect the nailer/stapler to any pressure source that may exceed 120 PSI (0.8 MPA).
Page 7
Checking the Nailer/Stapler for Proper Operation: WARNING BEFORE EACH USE, YOU MUST CHECK FOR THE PROPER OPERATION OF THE WORK CONTACT ELEMENT (WCE). • The WCE is the mechanism on the nailer/stapler that is pressed into the work piece prior to pulling the trigger.
• For the nailer/stapler to operate, your finger must first be off the trigger and the work contact element of the nailer/stapler then pressed against the work piece. Once the work contact element is pressed against the work piece, pull the trigger to drive the fastener into the work piece. •...
Page 9
Troubleshooting, continued Symptom: Air leak near top of nailer/stapler or in trigger area. Problem Loose screws. Worn or damaged o-rings or seals Symptom: Nailer/stapler does nothing or operates sluggishly. Problem Inadequate air supply. Inadequate lubrication. tions. Worn or damaged o-rings or seals. Symptom: Air leak near bottom of nailer/stapler.
Need help?
Do you have a question about the AIR-PLUS 691164 and is the answer not in the manual?
Questions and answers