Table of Contents
Advertisement
Problem
The display shows
. All buttons are
inactive, except the the
On/Off .
The appliance makes
an unusual noise and
vibrates.
The programme dura‐
tion increases or de‐
creases during pro‐
gramme execution.
The washing results
are not satisfactory.
Too much foam in the
drum during the wash‐
ing cycle.
After the washing cy‐
cle, there are some
detergent residues in
the dispenser drawer.
The appliance does
not dry or does not dry
correctly.
The laundry is full of
different colours fluff.
After the check, activate the appliance. The programme continues
from the point of interruption.
If the problem occurs again, contact the Authorised Service Centre.
The necessary data for the service centre are on the rating plate.
Possible solution
•
The appliance is downloading any available updates. Wait un‐
til the update process is complete. If you deactivate the appli‐
ance during update, it resumes when you activate the appli‐
ance again.
•
Make sure the levelling of the appliance is correct. Refer to
"Installation instruction".
•
Make sure that the packaging and/or the transit bolts are re‐
moved. Refer to "Installation instruction".
•
Add more laundry in the drum. The load may be too small.
•
The ProSense System is able to adjust the programme dura‐
tion according to the type and the laundry load size. Refer to
"The ProSense System load detection" in "Daily Use" chapter.
•
Increase the detergent quantity or use a different detergent.
•
Use special products to remove the stubborn stains before
you wash the laundry.
•
Make sure that you set the correct temperature.
•
Decrease the laundry load.
•
Reduce the quantity of detergent or the number of tablets or
single-dose detergents.
•
Make sure that the flap is in the correct position (UP for pow‐
der detergent - DOWN for liquid detergent).
•
Make sure you have used the detergent dispenser according
the indications given in this user manual.
•
Turn the water tap on.
•
Make sure the drain filter is not clogged.
•
Reduce the laundry load.
•
Make sure you have set the correct cycle. if necessary, set
again a short drying time.
The fabrics washed in the previous cycle released fluff of a differ‐
ent colour:
•
The drying phase helps to eliminate some fluff.
•
Clean the clothes with a fluff remover.
In case of an excessive amount of fluff in the drum run the special
programme to clean it (refer to "Fluff in the fabrics" for more de‐
tails).
ENGLISH
49
Advertisement
Table of Contents
