Advertisement
6.2 CONTROLLER WIRING
+
Red is for positive.
-
Black is for negative.
Use bolt driver to remove the 4pcs screws on the backside of the meter box and open
it, then install the cables from the wind turbine and battery to the power meter box
board as the following photo:
Important
Wind"+" is Wind turbine"+" ;
Wind"-" is Wind turbine"-" ;
Assume to finish all the other connection first and the connection to the battery is the
final step.
Do not make a wrong positive and negative connections to the power meter box or the
battery bank. The wrong positive and negative connection or positive and negative in
short circuit condition will damage the power meter box or wind turbine controller, the
warranty will not cover.
Note:
When the green light is on or flashing, it is normal charging.
Please connect with power meter box in any time, without power meter box positive and
negative direct short circuit easily damaged internal controller in wind condition, the
warranty will not covered. The power meter box main function is display and break the
wind turbine, the MPPT controller in the wind turbine body.
Power Meter box
From wind turbine
B"+" is battery"+"
B"-" is battery"-"
Page
of
+
Red is for positive.
-
Black is for negative.
Wind-
Wind+
To battery
B+
B-
Advertisement
