Global G3499A Operating Instructions, Parts List, Warranty, & Warranty Repair Center

Heavy duty pneumatic/ hydraulic blind riveter

Operating Instructions, Parts List, Warranty, & Warranty Repair Center

IMPORTANT! Read carefully before operating this tool. Failure to operate any power tool

properly can result in personal injury and/or property damage!

Blind Rivet Setting Capacity..... Max.9/32"

Traction Power (Lbs).........................3300

Air pressure (PSI) ............................... 90

Hose Size (ID) ................................... 3/8"

Air Inlet (NPT) ................................... 1/4"

1. Always wear approved eye protection.

2. Have throttle in "off" position when connecting to air supply.

3. Disconnect tool before performing service, changing accessories, or when not in use.

4. Always be in a safe working distance from others when using tools.

5. Keep tools clean and oiled for best and safest performance.

6. Follow instructions for lubricating and changing accessories.

7. Do not wear loose fitting clothing and remove watches and rings.

8. Always use proper hose and fittings. Never use quick change couplings attached at tool.

9. Keep proper footing and balance at all times.

10. Never carry tools by the hose. Keep hoses from heat, oil, and sharp edges. Check hoses

for weak or worn condition before each use, making certain that all connections are

secure.

Lubricate the tool daily with a good grade of air tool oil. The oil can be applied directly into

the air inlet of the tool and then run the tool. A rust inhibitor oil is acceptable for air tools.

Tools of this class operate on a wide range of air pressure. It is recommended that air

pressure of these tools measure 90 PSI at the tool while running free. Higher pressure and

unclean air will shorten the tool's life and may create a hazardous condition.

Water in the airline will cause damage to the tool. Ensure that the air tank is drained daily

Clean the air inlet filter screen on at least a weekly basis. The recommended hookup

procedure can be viewed in the illustration below.

Model # G3499A

Heavy Duty Pneumatic/

Hydraulic Blind Riveter

Rivet Size ....................................3/16",1/4"

Avg. Air Consump.(cfm)...................... 1.0

Overall Length .................................12-1/2"

Weight (Lbs) ............... ....................... 5.3

Safety

Table of Contents

Do you have a question about the G3499A and is the answer not in the manual?

Page 1 Model # G3499A Heavy Duty Pneumatic/ Hydraulic Blind Riveter Operating Instructions, Parts List, Warranty, & Warranty Repair Center IMPORTANT! Read carefully before operating this tool. Failure to operate any power tool properly can result in personal injury and/or property damage! Blind Rivet Setting Capacity…..
Page 2 The air inlet, used for connecting air supply, has standard 1/4” NPT American Thread. Line pressure should be increased to compensate for unusually long air hoses (over 25 feet). Minimum hose diameter should be 1/4” I.D. and fittings should have the same inside dimensions.
Page 3 Model # G3499A Heavy Duty Pneumatic/ Hydraulic Blind Riveter STANDARD ACCESSORIES: Index Description 11519 5/32" Nosepiece 11517 3/16" Nosepiece 11518 9/32" Nosepiece 11508 Jaws (3pcs / set) 11559 Wrench 11548 Plastic Bottle 11561 Spanner (19/21mm) 17S19 Wrench 17/19mm " * " REPAIR KIT ==> T115RK Part No.
Page 4 One Year Limited Warranty GLOBAL Industrial air tools carry a limited 1 year warranty to be free from defects in material and workmanship for one year from date of purchase. We will repair or replace at our discretion any defective part or unit which proves to be defective in material or workmanship during this 1 year period.